Enjoying in a car
≥Do not leave the unit on a surface that may become hot such as a dashboard. The unit is not
≥DRIVER MUST NOT OPERATE OR VIEW THIS UNIT WHILE OPERATING THE VEHICLE.
Doing so will distract the driver and could cause a collision resulting in serious injury or property damage.
Enjoying video in the back seat with the Headrest Mounting Bracket
You can enjoy video in the back seat attaching the unit to the back of the front seat.
≥Please insert the disc before attaching the unit to the headrest mounting bracket.
≥Do not attach or detach the unit or the bracket while the car is moving.
≥Do not attach the unit in the following locations:
–anywhere other than the back of the front seat
–where it can be viewed or operated by the driver
–where it interferes with the driver’s operation of the vehicle
–where it interferes with the operation of an airbag
≥Ensure that the bracket belt is securely fastened and check the lock on the unit. Refer to installation instructions.
In the event of an accident, sudden acceleration or braking, the unit could become loose and cause injury or property damage.
≥Only use the Panasonic bracket supplied to attach the unit to the car seat.
1 Attach the headrest mounting bracket to the front seat.
1 Adjust the headrest so there is an open space of about 3 cm.
Headrest Mounting
Bracket (included)
3 Attach the unit to the bracket.
While holding the unit with both hands, line up the unit just below the protruding sections on the bracket. Press the unit down about 4 to 5 mm so that the protrusions on the bracket fit into the holes on the bottom of the unit.
≥Please check the following points before use.
–The bracket is securely fastened to the unit.
–The unit is not loose and cannot be lifted upwards.
Line up the protruding sections here.
click!
When correctly attached, you will hear a locking sound.
Attach to the seat so that the label side of the bracket can be seen from the rear of the seat.
2Close the buckle and adjust the belt until it fits tightly around the headrest.
Side view
DO DO NOT
If this space is larger than 3 cm, the unit could become loose and cause injury in the event of an
Diagram of the attached bracket and unit
Use the monitor in the open position as shown in the illustration below to prevent abnormal audio or damage resulting from vibrations in the car.
The angle of the monitor can be adjusted up to about 30o.
≥The angle of the monitor
may shift while driving due to vibration, etc.
accident etc.
2 Adjust the monitor.
Rotate the monitor backwards so the screen is facing out. (➜ 4, Adjusting the LCD angle)
30˚
≥Depending on the type of headrest, you may not be able to attach the bracket.
DO | DO NOT |
23 cm or less | In the event of an accident etc., the unit | |
could become loose and cause injury. | ||
|
Releasing the unit from the bracket
RQT9201
14
Release button
1Press the release buttons (left and right) in towards the center of
the bracket.
2Lift the unit up to release it.
≥Do not press the release buttons any time other than when detaching the unit from the bracket.
