COLD BEVERAGE SET-UP (OPTIONAL FMD-2 ONLY)
Cold beverages may be dispensed from the left dispense position as follows:
1.Disconnect the dispenser from the power source.
2.Remove the lower front access panel.
3.Locate the Hot/Cold jumper connection near the whipper panel in the main wiring harness.
4.Remove the Hot jumper connection (red jumper plug) from the main wiring harness and connect the Cold jumper connection (blue jumper plug) to the main harness.
5.Replace the lower front access panel and reconnect the dispenser to the power source.
CLEANING
Refer to the decal on the rear of the dispenser door for cleaning recommendations and proccedures.
The use of a damp cloth rinsed in any mild,
ADJUSTMENTS
The beverage solenoid is preset to dispense approximately one ounce per second. This amount can be adjusted:
1.Disconnect the dispenser from the power source.
2.Remove product hopper(s).
3.Remove the hole plug(s) in the auger motor mounting panel.
4.Rotate the control at the base of the solenoid clockwise to decrease or counterclockwise to increase the amount of water.
5.Reinstall plug(s) and hopper(s).
HOPPER MOTOR SPEED ADJUSTMENT (FMD-1)
The hopper dispense rate is preset at the factory. With 8 tooth gear and auger wire the preset dispense rate is approximately 3 to 5 grams per second. With 12 tooth gear and auger wire the preset dispense rate is approxi- mately 5 to 7 grams per second. The hopper dispense rate can be adjusted to produce a wide range of dispense rates as follows:
1.Set the tank heater switch to the off position.
2.Open the top front cover of the dispenser and remove the two screws securing the top cover.
3.Remove the top cover assembly and set it aside.
4.Locate the motor speed adjuster (leftmost) on the dispenser cabinet top cross member.
5.Using extreme care not to touch the live terminals of the tank heater, adjust the motor speed by rotating the motor speed adjuster to the desired point, ranging from minimum (full counterclockwise) to maximum (full clockwise.)
6.After the motor adjustment is complete, replace the top cover assembly, securing it with the two screws, and return the tank heater switch to the on position.
HOPPER MOTOR SPEED PROGRAMING (FMD-2)
The hopper dispense rate is preset at the factory. With 22 tooth gear and auger wire the preset dispense rate is approximately 3 to 5 grams per second. With 32 tooth gear and auger wire the preset dispense rate is approximately 5 to 7 grams per second. The hopper dispense rate can be adjusted to produce a wide range of dispense rates as follows:
1.Place the rinse/run switch in the center (program) position.
2.Place the increase/decrease switch in the desired (increase or decrease) position.
3.Press and release the dispense switch for the chamber you wish to adjust. Each time the dispense switch is pressed, the rinse L.E.D. will flash, and the motor speed for that hopper will be increased/decreased by approximately 2 1/2%.
6 | 29112 101598 |
|
