Xerox DocuPrint 96MX OS1927 This system does not support Ethernet processing, OS1961, Adjustment

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS1927 This system does not support Ethernet processing

The command entered applies only to Ethernet. The system is not equipped with the Ethernet Controller Option for operating on the network.

Action None.

OS1928 Complex page encountered. System adjusting performance.

A page has been encountered that cannot be formatted for print in the normally allowed time. The system will dead cycle without feeding paper until formatting is complete. The page will print but system throughput performance will be degraded.

Action None.

OS1930 System not configured for selected process.

The system does not contain hardware needed to perform the requested task.

Action None.

OS1950	FCB received contained no channel assignments.
	The Forms Control Buffer (FCB) sent from the host was not coded
	correctly; channels were not specified telling which data should be
	printed on which line.
Action	Retransmit the FCB with channel assignments. (Refer to your
	DocuPrint 96/DocuPrint 96MX LPS Operations Reference for
	additional information.)

OS1959	Partial set delivered to bin before switch occurred.
	An incomplete set of printed output was sent to the current bin before
	the system could complete your request to change to another bin.
Action	Check and discard, if incomplete, the set delivered to the first bin.

OS1960 Print quality adjustment will cause partial set ejection.

This message is displayed if print quality adjustment will cause a partial set to be ejected from the finishing module‘s compiler tray.

Action None.

OS1961	Simplex feeding from tray 2 may cause incomplete print quality
	adjustment.
	Tray 2 does not have adequate capacity to perform a simplex mode
	print quality adjustment (PQA) under certain conditions.
Action	Select a different paper tray from which to feed your simplex print job.

6-40 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE