Xerox DocuPrint 96MX HP1130 Buffer file allocation less than specified, HP1150 Cannot start jobs

HIP (HOST INTERFACE PROCESSOR) MESSAGES

HP1130	Buffer file allocation less than specified
	The HIP buffer has less space than specified in the HIP.CMD file at
	installation. There may not be enough space to hold the entire job
	being sent.
Action	1.	Delete unneeded files from system disk to create more space.
	2.	Compress the disk. (Refer to your DocuPrint 96/DocuPrint
		96MX LPS Operations Reference chapter on managing LPS
		resources for additional information.)
	3.	Enter SETUP mode to change the HIP buffer file size. (Refer to
		your DocuPrint 96/DocuPrint 96MX LPS Operations Reference
		chapter on HIP-accessed communicating modes for additional
		information.)
	4.	Resend the job.

HP1140	Cannot abort job(s): xxxx (, yyyy, etc.)
	The HIP ABORT jobs command was entered. The system is unable
	to process the command because job(s) entered were not received
	by printer.
Action	1.	Verify that the job numbers were entered correctly.
	2.	Reenter the command.

HP1150	Cannot start job(s): xxxx
	The HIP START jobs command was entered, but the system is
	unable to process the jobs indicated because they are either not in
	the pending or receive state, or they have already been started.
Action	1.	Verify that the job numbers were entered correctly.
	2.	Reenter the command.

HP1160 Logging already enabled

You have entered the HIP LOG [START] command. The system is informing you that the log is already enabled.

Action None.

HP1170 Log file allocation less than specified

The system is informing you that there is insufficient disk space in the file system for the number of log entries specified in the LOG ENTRIES command. The system allocates the largest possible number of entries available for the disk space.

Action None.

HP1171 New log file created

A new log file has been created.

Action None.

4-4 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE