Xerox DocuPrint 96MX HP1299 Xpaf communications recovered, HP1300 Assuming negative confirmation

HIP (HOST INTERFACE PROCESSOR) MESSAGES

HP1299 XPAF communications recovered

HIP can now receive data via the XPAF communication mode. Data received but not yet written to system disk will be copied from memory (saved at system error restart) and written to system disk. The system then reestablishes the communications link and continues to receive the next block of data.

Action None.

HP1300	Assuming negative confirmation
	A confirmation prompt requiring a YES or NO response was
	displayed. No response was entered within the system’s time limit.
	The system is responding as if N were entered.
Action	If the Y response was intended, reenter the command, responding to
	the confirmation prompt within the system time frame of 30 seconds.

HP1320	Function is not supported by current host
	The requested function cannot be carried out by the current host.
Action	None.
HP1325	Command not permitted by current host
	You are currently logged on to the system at a level less than 2. The
	command you attempted to enter cannot be accepted at your present
	level.
Action	1. Log off and then log on at level 2.
	2. Refer to the appropriate DocuPrint 96/DocuPrint 96MX LPS
	Operator Guide.
HP1330	Buffersize=xxx, utilization=yy% zzzz blocks used, uuuu blocks
	available.
	This message provides the number of blocks available and the
	amount of the buffer already used.
Action	None.
HP1340	Known and current hip hosts:
	This message lists the available and currently-used HIP hosts for
	your system.
Action	None.
HP1410	End of HIP diagnostic
	The HIP command was entered during an interactive diagnostic test,
	or the system failed Test 2 or 3. The diagnostic test has been
	terminated.
Action	None.

4-8 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE