Panasonic NE-2156, NE-1856, NE-1846, NE-2146 Installation Instructions for Stacking, Preparation

Installation Instructions for Stacking

IMPORTANT

1.Disconnect or unplug all units from the wall socket before attempting to stack.

2.For stacking installation, you must use the PANASONIC Joining Plate which is enclosed with this unit.

INSTALLATION

3.The following PANASONIC models only are suitable for stacking:

NE-1057, NE-1457, NE-1247, NE-1747, NE-1047, NE-1447, NE-1257, NE-1757, NE-1442, NE-1856, NE-1456, NE-1846, NE-1446, NE-2156, NE-2146

4.The maximum stacking height is the total heights of two units.

PREPARATION

Be sure the oven cavity is empty.

1.Stack the units and remove five screws (a) as shown in Fig.1.

2.Loosen the screw (b).

3.Projection on Joining Plate must face away from the oven. Place Joining Plate on the screw (b).

4.Attach and tighten five screws (a) and the screw (b). See Fig.2.

5.Ensure the top oven is at a safe and workable height.

(b)

Joining Plate
Projection	Joining Plate

Projection

(a)

Fig. 1 Fig. 2

Self Diagnostics Failure Code Explanation

This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs. What to do when a Failure Code appears: Disconnect the oven from the electricity supply and wait more than ten seconds before reconnecting. If normal operation does not resume, follow the next chart.

CODE	PROBLEM	WHAT TO DO
F01	Too high temperature of	The oven shuts off automatically. Disconnect the appliance from the electricity
	exhausted air	supply. The oven beeps continuously and resets for operation when cool. Move
		the oven to a cooler location. If the problem persists, call service agent.
F33-34	Defective thermistor circuit	The oven shuts off automatically. If the problem persists, call service agent.
F05	Defective memory IC	If the problem persists, call service agent. The oven will operate even if Failure
		Code appears, just not as designed. If the problem occurs during memory
		heating, press Stop/Reset pad. Then other memory program and manual heating
		will be possible.
F81-82	Defective relay circuit	If the problem persists, call service agent. The oven will operate even if Failure
		Code appears, just not as designed. Press Stop/Reset pad and try again.
F86-87	Defective relay circuit	The oven shuts off automatically. If the problem persists, call service agent.
F44	Defective control panel	The oven shuts off automatically. If the problem persists, call service agent.

Note: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.

- 17 -