Xerox DocuPrint 96MX manual OS1982 FCG exiting. Invalid profile encountered

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS1982	FCG exiting. Invalid profile encountered.
	(4050/4090/4650 only) The system cannot accept the parameters or
	values you have entered. The cause may be incorrect syntax, too
	many characters, etc. This message is followed by message OS1976
	PROFILE NOT LOADED.
Action	1.	Verify that your values and/or syntax are correct and retry the
		command.
	2.	If the message reappears, contact your supervisor or systems
		specialist.

OS1983	FCG exiting. Failure to connect to the iot.
	(4050/4090/4650 only) The FCG utility is unable to communicate with
	the printer. There may be a print job or another system task being
	processed.
Action	1. Retry the FCG command.

2.If the message reappears, look for other system or printer messages to explain the condition.

3.If still unable to run FCG, contact your supervisor or systems specialist.

OS1984		FCG exiting. Data value is out of range.
		(4050/4090/4650 only) FCG has checked to see that all the data
		values specified in your command are within allowable ranges before
		updating the printer‘s non-volatile memory (NVM). Some values you
		specified are out of range.
	Action	None.
		Note: The percentage of wire left on the spool parameter must be
		between 0 and 100 percent. A value greater than 100, for example,
		would be out of range.
OS1990		Pre-format form - using system default paper size
		The header of the specified form file lacks the proper edge mark
		information which is needed by the system to determine paper size.
		The system default paper size is used for the job.
	Action	None.
OS1991		No test patterns form available for specified source size
		No test pattern form file is available for the paper size requested.
	Action	Select a different paper size and retry the command.
		or
		Abort the operation.

6-44 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE