Xerox DocuPrint 96MX manual IF9000, IF9001, IF9002, IF9003, IF9004 No Such File, IF9005, IF9006

	IFU (INTERPRESS FONT UTILITY) MESSAGES
IF9000	**- DEVICE IS NOT READY -**
	The medium specified was not available when the operation was
	attempted, or during the operation.
Action	1. Prepare the medium for operation and retry the command.
	2. If the retry fails, replace the media and retry.
IF9001	**- END OF FILE HAS BEEN DETECTED -**
	An end of file (tape mark) has been encountered.
Action	None.
IF9002	**- END OF VOLUME HAS BEEN DETECTED -**
	The logical end of volume was detected during the task execution.
	The tape is left positioned between the two tape marks. (This
	condition is not detected during the read operations.)
Action	Reposition the medium to the beginning of where the WRITE
	operation should start and retry the operation.
IF9003	**- DEVICE IS FULL (FCP) -**
	This message indicates an attempt to write to a medium that is full.
Action	None.
IF9004	**- NO SUCH FILE -**
	The file being accessed does not exist.
Action	None.
IF9005	**- FATAL HARDWARE ERROR -**
	A fatal and unrecoverable hardware error has occurred during the
	operation. For example, a bad block detected on the medium is being
	used.
Action	Contact your systems specialist or Xerox Customer Service.
IF9006	**- FATAL DEVICE ERROR -**
	A serious error has occurred on the medium.
Action	1. Select the abort option when the display prompts you to choose
	retry, ignore, or abort.
	2. Contact your systems specialist or Xerox Customer Service.
IF9007	**- TAPE UNIT IS offline-**
	The magnetic or cartridge tape is not online.
Action	1. Place the magnetic medium in the online operating mode.
	2. Retry the job.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 5-39