Xerox DocuPrint 96MX manual OS2296 Log printing not allowed until system status=’Idle

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS2296	Log printing not allowed until system status=’Idle
	The system must be offline and not printing to process a log print
	request.
Action	Complete or abort any current jobs, enter the OFFLINE command
	and then resubmit the log print request.

OS2310 Bin x not ready

For a system with one or two output tray(s), the selected output tray is not ready to begin processing print jobs.

This message may be displayed after you have entered ‘CONTINUE

O’. This message is followed by OS2000 ENTER ‘CONTINUE O’ TO

RESUME PRINTING, if printing is ready to begin.

Action None.

OS2320 Bin 2 not ready

The selected output tray must be ready in order for print quality adjustment to start. If not, this message is displayed after you have entered the CONTINUE O command. This message is followed by

OS2000 ENTER ‘CONTINUE O’ TO RESUME PRINTING. Action None

OS2341	Printing can be resumed using standard page recovery, %n%+
	or the entire finishing set can be reprinted, %n%+ Enter: “P” for
	standard page recovery %n%+ “S” to reprint the entire set %n.
	A jam has occurred during a report with SRECOVERY=ASK in effect.
Action	Select the desired recovery option.
OS2342	Reprinting of the entire finishing set required %n%+. Discard
	incomplete set from the finisher.
	Segment recovery is in effect. Follow clearance instructions, then
	press CONTINUE.
Action	None.
OS2350	STiming value ignored. Use FCG to set device parameters.
	An STIMING command has been detected in the datastream. This
	command is ignored because the printer relies on the operator using
	FCG to specify finishing-device timing parameters. This message is
	informational only.
Action	None.

6-56 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE