OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

 

 

OS2950

Software timing problem has caused a printer cycle-down

 

Input is being processed too rapidly for output to print. Output has

 

stopped.

Action

Enter the CONTINUE O command to resume printing.

 

 

OS2960

Back up host to start of report or nn pages, whichever is less

 

The system is in a recovery mode after a software failure.

Action

Resend either the number of pages stated or the entire report that

 

was printing at the time of the failure.

 

 

OS2980

Function not available in this LOGON class

 

The usage of the entered command was restricted at installation by

 

an RCU (Restrict Command Usage) command.

Action

Obtain the correct password and log on at the required level. (Refer

 

to your DocuPrint 96/DocuPrint 96MX LPS Operations Reference

 

chapter on setting LPS parameters for additional information.)

 

 

OS2990

Use ‘PROBLEM’ at earliest opportunity.

 

The system has detected a hardware problem. (This message

 

occurs in conjunction with other messages describing problem.)

 

Printing can continue. However, if the condition is not corrected,

 

printing may stop eventually.

Action

1. Enter the PROBLEM command and record SAN codes

 

appearing on the display.

 

2. Contact your systems specialist or Xerox Customer Service.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE

6-71

Page 149
Image 149
Xerox DocuPrint 96MX manual OS2980 Function not available in this Logon class, OS2990 Use ‘PROBLEM’ at earliest opportunity