Xerox DocuPrint 96MX manual OS2710 Invalid command reenter, OS2715 Command ignored, retry later

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS2710	Invalid command reenter.
	A command was entered that the system does not recognize, or a
	command was improperly keyed in.
Action	1.	Reenter the command correctly.
	2.	If the message reappears, the command cannot be used with
		your system.

OS2711 CMD not allowed while diagnostic print job is in progress.

You have entered a command that cannot be processed because a diagnostic print job is being run.

Action None.

OS2712	Command not allowed while task is running.
	The command entered cannot be processed while the current task is
	ongoing.
Action	1.	Abort the current task or wait until it is completed.
	2.	Reenter the desired command.

OS2713 This command is no longer supported. See -11
	The command entered is obsolete; your system cannot respond.
Action	1.	Refer to your DocuPrint 96/DocuPrint 96MX LPS OSS Program
		Description (“-11”) for the correct command for the desired
		process.
	2.	If information cannot be located, contact your systems
		specialist or Xerox Customer Support.

OS2714 Unable to obtain status at this time. Retry

The PRNTRSTATUS or JOBS command cannot be honored at this time. The PRNTRSTATUS command will not be honored while output is establishing communications. The JOBS command may not be honored if either input or output is performing a report transition or is near the end of the job.

Action Retry.

OS2715	Command ignored, retry later.
	The command entered cannot be processed because it conflicts with
	an ongoing process.
Action	Reenter the command after the process is completed.

6-64 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE