Xerox DocuPrint 96MX manual OS Level 4 System or tape problem

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS Level 4: System or tape problem

States a problem and explains what action(s) to take.

OS4010 Cannot find end of tape reflector strip. ‘CONTINUE I’

The system did not encounter the End of Tape (EOT) label.

Action 1. Enter the ABORT I command to cancel the job.

2.Clean the magnetic tape drive to ensure read was accurate. (Refer to the maintenance chapter in your DocuPrint 96/ DocuPrint 96MX LPS Operator Guide.)

3.Restart the job. If the message reappears, do one of the following:

a.Enter the CONTINUE I command to resume processing. If any “Label Error” messages appear, continue pressing the <CON> key until the job prints.

Note: Check output for pages formatted incorrectly. You may wish to recreate the job.

or

Enter the ABORT I command to cancel the job.

b.Check JSL and make any changes necessary. (Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations Reference chapter on job control.

c.If there are no JSL errors, enter the START n, DUMP command to obtain a tape dump for analysis.

d.Recreate the job, ensuring tape labels are correct. (Refer to your Xerox LPS Tape Formats Manual.)

OS4050	Forms/Fonts/Graphics values are too large. Enter new values
	via the Forms/Fonts/Graphics command
	The command FORMS n, FONTS n, or GRAPHICS n was entered
	with an n value greater than the system permits per job. (Maximum
	allowable: fonts—128; forms—64; graphics—128.)
Action	Reenter the command with a value within the acceptable range.
	(Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations
	Reference chapters on using the font editor and using graphics, or
	the DocuPrint 96/DocuPrint 96MX LPS Forms Creation Guide.)

OS4100	Printer is in diagnostic mode. Call for service.
	The printer is in a standalone diagnostic mode and cannot process
	any communication.
Action	Contact your systems specialist or Xerox Customer Service.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-81