Xerox DocuPrint 96MX manual OS2683 Change housing for color printing or, OS2692 Empty output tray

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS2683 Change housing for color printing or

This message is displayed when a problem occurs with the current color housing. It is followed by these messages: OS2673 ENTER THE SUB INK COMMAND OR ABORT THE PRINT JOB and

OS2000 ENTER ‘CONTINUE O’ TO RESUME PRINTING.

Action None.

OS2690 Ensure proper stock is loaded and output tray is empty

In response to a PQA command, this message reminds you to make sure of the following:

•The stock you want to use for the print quality adjustment (PQA) is loaded in the paper tray

•The target PQA output tray is empty.

Action None.

OS2691		Ensure proper stock is loaded for Print Job
		This message appears after print quality adjustment is completed
		when STOP was specified in the PQA command, or if you have
		pressed the Stop button or entered PQA CANCEL.
	Action	Make sure the job stock is loaded.
		Note: Be aware that if you enter the PQA CANCEL command, the
		housing on which PQA was being performed will not be ready.
OS2692		Empty output tray
		For a two output tray system, the selected output tray must be empty
		in order for print quality adjustment to start. This message appears
		after print quality adjustment is completed when STOP was specified
		in the PQA command.
	Action	None.
OS2700		Key-in lost. Reenter.
		The system was unable to process the command when entered
		because another ongoing process temporarily conflicted with it.
	Action	Wait a few seconds and reenter desired command.
OS2705		Recovery in progress... keyin not allowed.
		Recovery is currently in progress. The attempted operation was
		ignored.
	Action	Wait for recovery to complete, following any additional instructions.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-63