OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

 

 

OS2800

Move or space function complete.

 

The system has completed spacing over information on magnetic

 

tape as requested.

Action

Enter the CONTINUE I command if the place where input is resuming

 

has the same JDE and JDL as before SPACE command was

 

entered.

 

or

 

If JDE/JDL are different than before the spacing function, enter the

 

CONTINUE command followed by a new JDE and JDL ID (CON

 

“jde,” “jdl”). (Refer to the offline chapter in your DocuPrint 96/

 

DocuPrint 96MX LPS Operator Guide.)

 

 

OS2810

Start-up message from Job Tape follows:

 

This message appears in a single report mode. A report delimiter or

 

forms information message will be displayed next.

Action

Watch the printer control console display for a forthcoming

 

information message.

 

 

OS2811

The following is a document-generated “jobstart” message:

 

This is an informational message displayed prior to printing the job.

 

The actual “jobstart” message will follow.

Action

None.

 

 

OS2812

The following is a document-generated “jobend” message:

 

This is an informational message displayed after the job has been

 

printed. The actual “jobEnd” message will follow.

Action

None.

 

 

OS2820

Task not allowed till system status = ‘Idle’

 

The system must be offline and not printing to process the requested

 

task. The message also appears if the REWIND command is entered

 

or the Rewind button is pressed while a tape job is printing.

Action

1. Wait until the tape job completes before rewinding the tape.

 

or

 

2. Complete or abort any current jobs.

 

3. Enter the OFFLINE command.

 

4. Enter the desired command.

 

 

OS2822

Do a reset before retrying operation.

 

Your desired operation cannot be processed until the system has

 

been reset.

Action

1. Select Reset or enter the RESET command.

 

2. Retry the applicable operation.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE

6-67

Page 145
Image 145
Xerox DocuPrint 96MX manual OS2800 Move or space function complete, OS2810 Start-up message from Job Tape follows