Xerox DocuPrint 96MX manual HP1420 End of test 3 analysis, HP2010 No host selected

HIP (HOST INTERFACE PROCESSOR) MESSAGES

HP1420 End of test 3 analysis

The system failed Diagnostic Test 3. HIP has completed analysis of Test 3 results and has identified the data line that has failed. This message follows message HP9431 or HP9432.

Action None.

HP2010	No host selected
	A host has not been selected for HIP.
Action	Enter the appropriate HIPHOST command. (Refer to your DocuPrint
	96/DocuPrint 96MX LPS Operations Reference chapter on HIP-
	accessed communicating modes for additional information.)

HP2020	Selected host not present on system
	The host selected is not available on your system.
Action	Contact your systems specialist or Xerox representative.
HP2030	“ALL” not allowed at current logon level
	HIP ONLINE ALL was entered, but the current LOGON level does
	not support HIP ONLINE ALL.
Action	None.
HP2090	Host interface must be online. Enter HIP ‘ONLINE’
	or
	Host interface must be online. select or enter ‘HIP ONLINE’
	Host interface is not online.
Action	Enter or select the HIP ONLINE command.
HP2100	Host file buffer full - enter HIP START
	or
	Host file buffer full - select or enter HIP START
	The HIP STOP command was entered while the system was online.
	Input continued transmitting files until the HIP buffer was full. Host
	transmission has now stopped.
Action	Enter or select the HIP START command to print files in the HIP
	buffer.
HP2110	All jobs will be lost: confirm with ‘Y’.
	The HIP ABORT ALL command was entered. This message is a
	confirmation prompt.
Action	1. Enter Y to abort all jobs being processed.
	or
	2. If you do not wish to abort all jobs, enter N.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 4-9