Xerox DocuPrint 96MX DS8010 Tape error xxxx...DSR aborted, DS8020 Tape is read only...DSR aborted

DSR (DISK SAVE AND RESTORE COMMAND) MESSAGES

DS8010	Tape error xxxx...DSR aborted
	The system has encountered a device error from which it was unable
	to recover after several attempts. DSR task is aborted.
Action	1.	Clean the tape drive and retry the task. (Refer to the
		maintenance chapter in your DocuPrint 96/DocuPrint 96MX
		LPS Operator Guide.)
	2.	If the problem continues, replace the save tape.

DS8020	Tape is read only...DSR aborted
	The tape is designed to be read but not written. Data cannot be
	copied onto it. The DSR task is aborting.
Action	Use a different tape.

DS8030	Tape is write protected
	The save tape does not have a write enable ring. Data cannot be
	copied onto it. The DSR task will abort.
Action	1.	Add a write enable ring to tape.
	2.	Reenter the DSR command.

DS8040 6250 not supported, defaulting to 1600

The DSR 6250 command was entered, but your system does not support a recording density of 6250 bpi. The system will record at 1600 bpi.

Action None.

DS9010	Disk error xxxx...DSR aborted
	The system has encountered an error on disk from which it was
	unable to recover after several attempts. The DSR task is aborted.
Action	Contact your systems specialist or Xerox Customer Service.

DS9020	DSR aborted
	The DSR task has aborted due to a hardware error.
Action	Retry the DSR task. If the problem continues, contact your systems
	specialist or Xerox Customer Service.

DS9030	File structure integrity error...DSR aborted
	This message occurs during the DSR process of saving disk files to
	tape. Either multiple-allocated or nonallocated blocks have been
	encountered. The DSR process has been cancelled.
Action	1. Enter the COMPRESS command.

2.If the compress procedure fails, reformat the disk. (Refer to your DocuPrint 96/DocuPrint 96MX LPS Operations Reference.)

2-2 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE