Xerox DocuPrint 96MX manual OS1980 Performing print quality adjustment

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES

OS1979	NVM address . . .
	(4050/4090/4650) This message either lists a series of four wire
	management or seven third party device parameters for you to enter
	or simply gives the current values.
	n8 :% wire remaining on spool:
Action	1. Enter the requested wire management parameter values as
	appropriate or contact your supervisor or systems specialist.
	N
	n9	: Stitcher disable
	N10 : %low wire
	Message threshold: n
	or
	n1	:Feature control: n
	n2	:Skip pitch set: n
	n3	:Delay sheet exit: n
	n3	:Delay sheet exit: n
	n4	:Sheet exit pulse: n
	n5	:Delay end of set: n
	n6	:End of set pulse: n
	n7	:Delay all output:
	2. Enter the requested finishing device parameter values as
	appropriate.

Notes for device parameter values:

•

•

•

n1 :FEATURE CONTROL is 0.

n2 :SKIP PITCH SET is always 1.

For n3 through n 7 each value is doubled by the system.

(For example, if DELAY SHEET EXIT is equal to 50 milliseconds, you should specify a value of 25.)

•n represents a value which corresponds to non-volatile memory (NVM) locations in the system.

OS1980 Performing print quality adjustment.

This message informs you that print quality adjustment has started.

Action None.

OS1981 Print quality adjustment has been completed.

This message informs you that print quality adjustment has completed successfully.

Action None.

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-43