This Beard/Hair Trimmer is for the trimming and care of mustaches, beards and hair. Trimming length can be adjusted between 2 to 18mm. The trimmer can be operated either from an AC power source or on its own rechargeable battery.
Parts identification
(see fig. 1)
ASwitch
Slide up to turn on, slide down to turn off.
BCharge Indicator Lamp
Lights when the unit is connected with the adapter J to an AC power source for charging.
CMain Blade
A precision
which can be used with the comb attachment E.
DQuick Adjust Dial
Turn the dial to a higher setting to
raise or lower the comb attach- ment E to the desired length (between 2 and 18mm).(see fig. 2)
EComb Attachment
Use this to control the trimming length. (see fig. 3)
FStationary Blade
GMoving Blade
HCleaning Lever
Push this lever to remove bits of hair caught between the station- ary blade and the moving blade.
IBlade Block
Release to remove the blade block from the housing to clean or replace the blade. (see fig. 7)
JAdapter
Use this to connect the trimmer
to an AC power source for recharging or for AC operation.
KOil
Lubricate the space between the stationary and moving blade with 2 or 3 drops of oil after use. (see fig. 9)
LCleaning Brush
Trimming length indicator
Indicator | Trimming Length |
12.0mm
23.0mm
34.5mm
46.0mm
57.5mm
69.0mm
710.5mm
812.0mm
913.5mm
1015.0mm
1116.5mm
1218.0mm
Operation
Charge the battery by plugging the trimmer into an AC source using the adapter. The switch should be set to 0·Charge during charging. An
AC operation
Plug the trimmer into an AC power source using the adapter with the switch set to 0·Charge. Wait about 10 seconds, then switch the trimmer on. After use, return the switch to the 0·Charge position.
Trimming of Beard
Place the angled face of the comb against the skin and cut the beard by moving the trimmer in all directions to obtain a uniform cut. (see fig. 4)
With curly facial hair, the comb attachment may not cut all of the hair. In this case, remove the comb attachment and use a conventional comb to draw out the remaining uncut hair. (see fig. 5)
When shaping the beard, remove the comb attachment. Place the angled edge against the skin and make the border of the beard even.
Maintenance
Blades
1.Brush out the cutting mechanism. (see fig. 6)
2.Hold body of the trimmer with Panasonic mark upwards, place the thumb against the blades, and push them away from the main body. (see fig. 7)
3.Push down the cleaning lever to raise the moving blade and brush in between the blades. (see fig. 8)
4.Put a few drops of oil on the blades. (see fig. 9)
Blade Life
Blade life will vary according to the frequency and length of use. For example, using the unit for 10min- utes every 3 days, the life expectancy is approximately 3 years. If cutting efficiency is reduced substantially despite proper maintenance, the blades have exceeded their service life and should be changed.
The replacement part no. is WER9601Y.
Battery life
Battery life will vary according to the frequency and length of use. If the battery is charged 3 times a month, the service life will be approximately 6 years. If the unit is left without being charged for more than 6 months, the charge will drain from the battery and their service life may be shortened.
Therefore, even when not using reg- ularly, it is recommended that the unit be recharged at least once every six months.
4 | 5 |