8
2How to charge thebattery
Using the rechargeable battery
Charge the battery by plugging the
Trimmer into an AC source using the
cord. The switch should be set to “0-
charge” during charging. Charge the
trimmer fully for 24 hours before us-
ing it for the first time, or when it has
not been used for more than 6
months. For normal use, charge it
fully for 1 hour. A full charge will give
40 minutes of use.
•The lamp lights while the battery is
being charged and flashes when
the charging is completed.
•The trimmer will become warm
while the battery is being charged,
but this is not a malfunction.
Using an AC power source
Plug the Trimmer into an AC power
source using the cord with the switch
set to “0-charge”. Wait about 1
minute, then switch the Trimmer on.
After use, return the switch to the “0-
charge” position.
3Adjusting the trimmingheight
1 Attach the trimming height attach-
ment (a) to the body.
2 The trimming height can be ad-
justed in 12 steps (b).
3 Press the trimming height adjust-
ment switch (c) and adjust to the
desired trimming height.
Indicator Beard Length
1 2.0 mm
•3.0 mm
3 4.5 mm
•6.0 mm
5 7.5 mm
•9.0 mm
7 10.5 mm
•12.0 mm
9 13.5 mm
•15.0 mm
11 16.5 mm
•18.0 mm
4Leveling the beardheight
1 Adjust the trimming height.
2 Trim with upward movements.
(Hold the comb part of the trim-
ming height attachment against
your skin in the opposite direction
to the hair growth.)
When trimming a lot of beard, the
beard cuttings accumulate inside the
trimming height attachment. If this
happens, empty the attachment
when necessary.
5Shaping the beard andaligning the edges
Remove the trimming height attach-
ment from the body.
Trim with the blade at a 90° angle to
the beard.
(Trim a little at a time in order to pre-
vent trimming too much.)
OS01L015_ER214-ER216_E 1/17/02, 4:43 PM8