English
1Cleaning the shaver
2 |
| 5 |
|
| |
| 4 | 3 |
|
|
1
clean
y dr
charge
status
select
1 Insertplug. the appliance
2 Plug in the adaptor.
•Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent.
3 Pull up the arm.
4 Remove the protective cap 1 and then attach the shaver.
•Turn the shaver off before attaching.
•Check that the outer foil is not deformed or damaged when you are attaching the shaver.
5 Push down the arm.
6 Press [select] to select the course.
•Each time you press [select], the course changes from “Clean/Dry/Charge” “Clean/Dry” “Dry/Charge” “Dry” “Charge”.
•The courses start approximately 6 seconds after they are selected.
•The course will be aborted if the power is cut off. In this case, perform the course again from the beginning.
•Do not detach the detergent cartridge or the water tank as the cleaning liquid may spill causing a malfunction.
|
| Course selection indications | On shaver |
|
| Course completion summary | ||||||
Course | On recharger | Changeable course | | On recharger | On shaver | Time required | ||||||
| ||||||||||||
| clean | dry | charge | halfway through |
|
| clean | dry | charge |
| (guide) | |
1Charge |
|
| * | 2345 | Glows | |
|
|
| Blinks | 1 hour | |
2Clean/Dry/ |
|
|
| 3 | Glows while | |
|
|
| Blinks | 4 h 30 min | |
Charge |
|
|
|
| charging |
|
|
|
|
|
| |
3Clean/Dry |
|
|
| 2 | – | |
|
|
| – | 3 hours | |
4Dry/Charge |
|
|
| 235 | Glows while | |
|
|
| Blinks | 4 h 20 min | |
|
|
|
|
| charging |
|
|
|
|
|
| |
5Dry |
|
|
| 234 | – | |
|
|
| – | 2 h 50 min | |
*The lamp goes out in 6 seconds.
