CAUTION:
•When using, the Grinding disc guard must be installed on the tool so that the closed side of the guard always faces toward the op- erator.
•Ensure that blotters are used when they are provided with the bonded abrasive product and when they are required;
WARNING:
•Always use supplied guard when using tool. Grinding disc can shat- ter during use and Grinding disc guard helps to reduce chances of personal injury.
1.Install the Grinding disc guard, and then securely tighten the screw.
| 1 | 1. | Clamp nut | |
Make sure | 2. | Grinding | ||
| ||||
|
| disc | ||
the side. |
|
| ||
| 3. | Disc flange | ||
|
| |||
| 2 |
|
| |
| 3 |
|
|
2. Install the disc flange and the disc to the | |
spindle in order as shown in the figure. | |
3. Tighten the clamp nut onto the spin- | |
dle so that hollow side faces oppo- | |
site direction to the disc. |
|
4. Push the Spindle lock button to se- | |
cure the spindle in place, and then | |
use the clamp nut wrench to tighten | |
the clamp nut securely. |
|
| 1. Spindle lock |
1 | button |
| |
5.To remove the grinding disc, follow the installation procedure in reverse.
Attaching or Removing Battery Pack
1.To connect the battery pack:
Line up the alignment marks and at- tach the battery pack.
•Slide the battery pack until it locks into position.
Alignment marks 
2.To remove the battery pack:
Push on the button from the front to release the battery pack.
Button 
V. OPERATION
NOTE:
Be aware that this tool is always in an operating condition, since it does not have to be plugged into an elec- trical outlet.
Power switch operation
1. Power switch
1
CAUTION:
•Before inserting the battery pack into the tool, always make sure that the power switch operates position when the rear of the pow- er switch is depressed.
•Power switch can be locked in “ON” position. Stay alert when locking tool in “ON” position and grasp the tool firmly using sup- port handle and grip.
- 12 -
