Attaching or removing battery pack
1.To connect the battery pack:
Insert the battery pack. It snaps into place to indicate proper connection.
2.To remove the battery pack:
Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body.
3.Support handle
Place the support handle at your favorite position and tighten the han- dle securely.
Loosen Tighten
Remove the handles when placing the battery pack in the storage case.
. OPERATION
Switch Operation
1.The speed increases with the amount of depression of the trigger. When beginning work, depress the trigger slightly to start the rotation slowly.
2.A feedback electronic controller is used to give a strong torque even in low speed.
3.The brake operates when the trigger is released and the motor stops imme- diately.
Note: When the brake operates, a braking sound may be heard. This is normal.
Forward/Reverse lever Operation
(Forward (
), Switch lock, Reverse (
))
CAUTION: Do not operate Forward/ Reverse lever until the chuck comes to a com- plete stop. Shifting during rotation of the chuck may damage the tool.
Forward Rotation Switch Operation
1.For forward rotation, set the lever to forward.
2.Depress the trigger switch slightly to start the tool slowly.
3.The speed increases with the amount of depression of the trigger for efficient tightening of screws and drilling. The brake operates and the chuck stops immediately when the trigger is re- leased.
4.After use, set the lever to its center position (switch lock).
Reverse Rotation Switch Operation
1.For reverse rotation, set the lever to reverse. Check the direction of rota- tion before use.
2.Depress the trigger switch slightly to start the tool slowly.
3.After use, set the lever to its center position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 15 possible settings or “
“ , “ 
“ position to the job.
CAUTION: Test the setting before actual operation.
Set the scale at this line.
- 7 -
