23
ADVANCED SETTINGS

PICTURE Adjustments

Item
PICTURE
BRIGHTNESS
COLOR
TINT
SHARPNESS
Effect Adjustments
Less More
Darker Brighter
Reddish Greenish
Adjusts the proper picture contrast.
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Adjusts color saturation.
Adjust for natural flesh tones.
Adjusts picture sharpness.
Notes:
“COLOR” and “TINT” settings cannot be
adjusted for “RGB/PC” and “DVI” input
signal.
•You can change the level of each function
(PICTURE, BRIGHTNESS, COLOR, TINT,
SHARPNESS) for each PICTURE MENU.
The setting details for STANDARD,
DYNAMIC and CINEMA respectively are
memorized separately for each input mode
(INPUT1, INPUT2 , INPUT3 and PC IN).
The “TINT” setting can be adjusted for
NTSC signal only during “VIDEO
(S VIDEO)” input signal.
In PICTURE, there is nor a noticeable
change even when contrast is increased
with a bright picture or reduced with a dark
picture.
Less More
Less More
Item
BLACK
EXTENSION
INPUT
LEVEL
W/B HIGH R
W/B HIGH B
W/B LOW R
W/B LOW B
GAMMA
AGC
Effect
Notes:
• Carry out “W/B” adjustment as follows.
1. Adjust the white balance of the bright sections using the “W/B HIGH R” and “W/B HIGH B” settings.
2. Adjust the white balance of the dark sections using the “W/B LOW R” and “W/B LOW B” settings.
3. Repeat steps 1 and 2 to adjust.
Steps 1 and 2 affect each other’s settings, so repeat each step in turn to make the adjustment.
• The adjustment values are memorized separately for each input mode (INPUT1, INPUT2 , INPUT3 and PC IN).
The adjustment range values should be used as an adjustment reference.
Less More
Less More
Less More
Less More
Down Up
Less More
Less More
OFF ON
Details
Adjusts the dark shades of the image in gradiation.
Adjustment of parts which are extremely bright and hard to see.
(This cannot be adjusted when the input signal is DVI.)
Adjusts the white balance for light red areas.
Adjusts the white balance for light blue areas.
Adjusts the white balance for dark red areas.
Adjusts the white balance for dark blue areas.
S CURVE 2.0 2.2 2.5
Increases the brightness of dark signal automatically.
On the remote control unit, while the “ADVANCED SETTINGS” menu is displayed, if either the N button is pressed at
any time or the ACTION ( ) button is pressed during “NORMALIZE”, then all adjustment values are returned to the
factory settings.
Helpful Hint (
N
/
NORMALIZE
Normalization)