Panasonic KV-S7075C 3, 4, 5, 6

Cleaning the Unit

∫Cleaning the paper and waiting sensors, double feed detector

How to clean sensors (detectors) and reflectors.

Remove the brush from the accessory blower and blow off the dirt with the blower.

1Turn off the scanner.

2Push the ADF door release to open the

ADF door.

3Blow off the dirt on the surface of the

paper sensor and waiting sensor with

an accessory blower.

4And also blow off the dirt on the

surface of the reflector sheet for the

waiting sensor with the accessory

blower.

5Blow off the dirt from the double feed

detector (G) and double feed detector

(R) with the accessory blower.

6Close the ADF door.

≥When you close the ADF door, close it

securely until it is locked.

Blower

Sensor (detector)

Waiting sensor

Reflector sheet

for waiting sensor

Paper sensor

Double feed detector (G)

Double feed detector (R)

Contents

Main Introduction About the documentation International ENERGY STAR Program Abbreviations Trademarks System Requirements Federal Communications Commission Requirements (For United States only) For FRG Users (For Germany Only) Table of Contents Before You Sta rt Appendix Operation Care and Maintenance For Your Safety For Users WARNING Power and Ground Connection WARNING CAUTION CAUTION Power Installation and Relocation Operating Safeguards Hollows Safety Information (For United Kingdom only) WARNING IMPORTANT Precautions Installation CD-ROM Roller Cleaning Paper Others Precautions Illegal Duplication Security Notice Caution Labels Component Identification Page Component Identification Power turn-on sequence 1 About the power indicator (LED) Loading Documents on the ADF Acceptable documents Feeding direction Documents must also meet the following conditions Feeding direction Less than 5 mm (0.2 in.) Notes about documents for scanning Scanning documents with pages of same sizes 2 3 4 5 6 7 8 Scanning documents with pages of different sizes 1 2 3 4 5 6 7 8 9 Adjusting the left and right document guides to their original position 1 2 3 Loading Documents on the Flatbed When scanning with the flatbed 1 2 3 Loading Documents on the Flatbed 4 5 6 7 Scanning thick documents Using Control Sheets A B Using Control Sheets About Printing Control Sheets 1 2 3 4 Center of the page Changing the Reference Plate Setting ADF reference plate setting 3 4 Page Clearing Paper Jams Removing paper jams from the paper slot 1 2 3 Clearing Paper Jams Removing paper jams from the exit path 1 2 3 Cleaning the Unit Outside of the scanner 2 3 Inside the scanner Cleaning the paper feed roller, separation roller, and double feed prevention roller 4 5 6 7 8 Cleaning the drive rollers and free rollers 4 5 Cleaning the drive rollers, free rollers, and exit rollers 4 Page Cleaning the paper and waiting sensors, double feed detector 3 4 5 6 Cleaning the starting, skew and ending sensors 3 4 5 Page Page Page Page Page Troubleshooting Symptom Possible Cause Remedy Troubleshooting Symptom Possible Cause Remedy Shading Adjustment Repacking Instructions 1 2 3 Specifications Specifications Index A B C D P R S T U