Panasonic KV-S7075C

Changing the Reference Plate Setting

5Close the exit door slowly until it clicks

into place.

∫Flatbed sheet setting

1Turn off the scanner.

2Fold the hopper tray in the direction of

the arrow (1).

3Open the document cover (2) and

remove the flatbed sheet from the

flatbed cover (3).

≥The flatbed sheet is attached to the

document cover with magnets.

4Turn the flatbed sheet over, and then

place it in the upper left corner of the

flatbed glass.

≥Set the flatbed sheet to the left.

5Close the document cover.

≥When you close the document cover,

close it securely until it is locked.

The flatbed sheet will become

magnetically attached to the document

cover.

Hopper tray

Document coverFlatbed sheet

Flatbed sheet

Standard mark

Contents

Main Introduction About the documentation International ENERGY STAR Program Abbreviations Trademarks System Requirements Federal Communications Commission Requirements (For United States only) For FRG Users (For Germany Only) Table of Contents Before You Sta rt Appendix Operation Care and Maintenance For Your Safety For Users WARNING Power and Ground Connection WARNING CAUTION CAUTION Power Installation and Relocation Operating Safeguards Hollows Safety Information (For United Kingdom only) WARNING IMPORTANT Precautions Installation CD-ROM Roller Cleaning Paper Others Precautions Illegal Duplication Security Notice Caution Labels Component Identification Page Component Identification Power turn-on sequence 1 About the power indicator (LED) Loading Documents on the ADF Acceptable documents Feeding direction Documents must also meet the following conditions Feeding direction Less than 5 mm (0.2 in.) Notes about documents for scanning Scanning documents with pages of same sizes 2 3 4 5 6 7 8 Scanning documents with pages of different sizes 1 2 3 4 5 6 7 8 9 Adjusting the left and right document guides to their original position 1 2 3 Loading Documents on the Flatbed When scanning with the flatbed 1 2 3 Loading Documents on the Flatbed 4 5 6 7 Scanning thick documents Using Control Sheets A B Using Control Sheets About Printing Control Sheets 1 2 3 4 Center of the page Changing the Reference Plate Setting ADF reference plate setting 3 4 Page Clearing Paper Jams Removing paper jams from the paper slot 1 2 3 Clearing Paper Jams Removing paper jams from the exit path 1 2 3 Cleaning the Unit Outside of the scanner 2 3 Inside the scanner Cleaning the paper feed roller, separation roller, and double feed prevention roller 4 5 6 7 8 Cleaning the drive rollers and free rollers 4 5 Cleaning the drive rollers, free rollers, and exit rollers 4 Page Cleaning the paper and waiting sensors, double feed detector 3 4 5 6 Cleaning the starting, skew and ending sensors 3 4 5 Page Page Page Page Page Troubleshooting Symptom Possible Cause Remedy Troubleshooting Symptom Possible Cause Remedy Shading Adjustment Repacking Instructions 1 2 3 Specifications Specifications Index A B C D P R S T U