45
Chapter 5
Useful Information
Before Requesting HelpProblem
The unit does not work.
“ ” flashes and an alarm tone sounds
when you press .
A busy tone sounds when you
press .
You cannot dial.
“ ” flashes during a conversation and
the call is disconnected.
Static, sound cuts in/out, fades.
Interference from other electrical units.
The handset does not ring.
The base unit does not ring.
Remedy
•
Turn the power ON (p.12).
•
Check the settings (p.9–15).
•
Charge the batteries fully (p.11).
•
Clean the charge contacts and charge again (p.11).
•
Unplug the AC adaptor and turn the power OFF to
reset.Plug in the AC adaptor and turn the power ON.
Then try again.
•
The handset has been cancelled or has not been
registered.Register the handset (p. 35).
•
Re-install the handset batteries and try again.
•
You are too far from the base unit.Move closer and
try again.
•
Plug in the AC adaptor.
•
Another handset is in use.
•
Check that the dialling mode selection is correct
(p.13).
•
The unit is in call prohibition mode.Cancel the mode
(p.29).
•
The dialled number is restricted.Cancel the number
(p.30).
•
Key lock mode is set.Cancel the mode (p. 24).
•
The handset is out of range.Move closer to the base
unit and make the call again.
•
Plug in the AC adaptor.
•
Locate the handset and base unit away from other
electrical appliances (p.5).
•
Move closer to the base unit.
•
Turn the power ON (p.12).
•
The ringer is set to OFF.Select the desired volume
level (p.14).
•
The ringer is set to OFF.Set to HIGH, MEDIUM or
LOW (p.15).
KX-TCD952EB(040~048) 00.3.30 1:38 PM Page 45