18
Answering System Feature (KX-TG1090/KX-TG1092/KX-TG1093/KX-TG1094 )
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Note:
• Error tones (2 long beeps) will sound
if a wrong remote access code is
entered. You can enter the remote
access code again. If this fails again,
the phone will release the line.
Keys
5
4
6
Functions
Starts and stops message
playback
Repeats the current message
Skips forward a message
Deletes the current message

Using the answering system remotely

1Use a touch tone phone and call your
phone number from outside.
2Press [ ] after you hear the greeting,
the greeting will be stopped.
3Enter the remote access code.
• New messages start to be played back.
• If there are no new messages, all
messages will be played back after a
long beep.
4Refer to following table and press
keys for corresponding operation.
Note:
• You can hang up at any time.
Remote commands
Remote accessing
Using a touch tone phone, you can call
your phone number from outside and
access the unit to listen to the voice
messages.
Important:
• In order to operate the answering
system remotely, you must first set a
remote code. This code must be
entered each time you operate the
answering system remotely.

Remote access code

A remote access code must be entered
when operating the answering system
remotely. This code prevents
unauthorised parties from listening to
your messages remotely. The factory
setting is "0000".

Changing remote access code

If you change the access code, please
write down your new access code as the
unit will not reveal the access code to you.
1[]
•"" flashes on the display.
2Press [ ] and enter the previous access
code then press [ /OK] to confirm.
• If a wrong access code is entered, a
long beep will be heard.
3Input a new access code (4 digits)
then press [ /OK] key.
4Input this new access code once
again for confirmation. >[ /OK]
• If a wrong access code is entered, a
long beep will be heard.
5[ ]

Turning call screening on / off

(handset number 1 only)

1[
]
•" " flashes on the display.
2[3 SCREEN]
3Press [ ] or [ ] to select between
“On” and “OFF”.
4[ /OK] to save the setting. >[ ]
Screening calls (handset number 1 only)
While a caller is leaving a message, you can
listen to the call through the handset
speaker. To adjust the speaker volume,
press [ ] or [ ] repeatedly. You can answer
the call by pressing [ ] on the handset.