54
Troubleshooting Cordless Telephone
Problem Cause & Remedy
“
No link to base. Place
on cradle and try
again.
” is displayed and an
alarm tone sounds.
•You are too far from the base unit. Walk
closer and try again.
•Place the handset on the base unit and try
again.
•Plug in the AC adaptor.
•Raise the base unit antenna.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
•Move the handset and the base unit away
from other electrical appliances (p. 3).
•Walk closer to the base unit.
•Raise the base unit antenna.
•Select a clearer channel (p. 23,38).
The handset and/or base unit
does not ring.
•The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 17).
•When the handset is on the base unit, the
handset does not ring. Only the base unit
rings when receiving a call.
The handset display is blank. •Charge the battery fully (p. 8).
You cannot program function
items.
•Programming is not possible while the unit is
being used.
•Do not pause for over 60 seconds while
programming.
•Walk closer to the base unit.
While programming or
searching, the unit starts to
ring and stops the program/
search.
•A call is coming in. To answer the call, press
[]
,
[]
or
[SP-PHONE]
. Start again from
the beginning after hanging up.
You cannot make a call with
the handset.
•Your handset is in remote operation mode
(p. 44). Exit by pressing
[OFF]
.
You cannot redial. •If the last number dialed was more than
32 digits long, the number will not be redialed
correctly.