Troubleshooting
56
“” is displayed and the
ANSWER ON indicator
ashes rapidly. No new
messages are recorded.
Memory is full. Erase unnecessary
messages (p. 46).
You cannot operate the
Answering System with the
base unit.
The handset user is operating the Answering
System, or is on the phone. Wait until the
IN USE/CHARGE indicator light goes out.
You cannot operate the
Answering System from a
touch tone phone.
Make sure you enter the correct remote code
(p. 48).
The Answering System may not respond if
the tones are too short to activate the unit.
Press each button rmly.
The Answering System is off. Turn it on
(p. 50).
You cannot operate the
Answering System with the
handset.
Someone is operating the Answering
System.
You are too far from the base unit. Walk
closer to the base unit.
The unit is recording a message. To answer
the call, press
[]
or
[]
.
While recording a greeting
message, the unit starts to
ring and stops recording.
To answer the call, press
[SP-PHONE]
,
[]
or
[]
. Start again from the beginning after
hanging up.
During playback, the unit
starts to ring and stops
playback.
To answer the call, press
[SP-PHONE]
,
[]
or
[]
. To resume playback, press
[MESSAGE/SLOW TALK]
after hanging up.
Caller ID information is not
displayed during message
playback (p. 45).
Caller ID information will not be displayed
if a message is recorded by using
[MEMO/2WAY REC]
(p. 47), or
if the Caller List is renewed and the caller
ID information is erased (p. 28).
Problem Cause & Remedy
FULL