:

Programming using the Base Unit

32 Document Version 2011-03
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 32)
– using the direct commands (page 33)
Some of the features can be programmed through the Web user interface (page 39).
LDirect command is the main method used in this User Guide.

Programming by scrolling through the display menus

1{MENU} (middle soft key)
2Press {^}, {V}, {<}, or {>} to select the desired main menu. i {SELECT}
3Press {V} or {^} to select the desired item in sub-menu 1. i {SELECT}
LIn some cases, you may need to select from sub-menu 2. i {SELECT}
4Press {V} or {^} to select the desired setting. i {SAVE}
LThis step may vary depending on the feature being programmed.
LTo exit the operation, press {EXIT}.
Note:
LSee page 33 for the default settings.
LIn the following table, ( ) indicates lines you need to select for the settings.
Main menu Sub-menu 1 Sub-menu 2 Page
Line status
m
––9
IP service Network setting DHCP*1 –
IP settings*1 –
Embedded web 39
Call features Call forward
(Line 1: 8 max.)
–Unconditional*1
–Busy*1
–No answer*1
35
Do not disturb*1
(Line 1: 8 max.)
36
Block anonymous*1
(Line 1: 8 max.)
36
Block Caller ID*1
(Line 1: 8 max.)
37
Ringer settings
(
Ringer volume –16
Ringer tone (Line 1: 8 max.) –
Interrupt tone ––