Panasonic mc-v41500 3 REPLACEMENT INSTRUCTIONS

3 REPLACEMENT INSTRUCTIONS

1. Place handle in low position.

2. Turn the vacuum cleaner over exposing the underside.

Release the lower plate by pressing the two (2) latches

that secure it inward.

3. Separate the lower plate from the vacuum.

1. Close the rear belt cover.

2. Hook the front of the lower plate in to the slots on the front

of the nozzle housing. Press the lower plate down into

place.

3. Fasten the lower plate by pushing the two (2) latches out-

ward.

4. NOTE: For general servicing, it is necessary to eliminate

pinching of any wire during reassembly. After servicing

any electrical component or enclosure, the unit should be

reassembled and checked for dielectric breakdown or

current leakage.

1. Follow th e remov al ins truc tio ns outl in ed in the AGITATOR

ASSEMBLY REMOVAL/INSTALLATION section.

1. Place the new belt around the motor shaft and follow the

installation instructions in the AGITATOR ASSEMBLY

REMOVAL/INSTALLTION secti on.

1. The brushes are not replaceable separately. When the

brushes need replacing, the agitator assembly will have

to be replaced.

2. Carefully lift up on the agitator assembly until it clears

both sides of the nozzle housing.

3. Remove the belt from the motor shaft by sliding it off

between the end of the shaft and the nozzle housing.

1. Place the belt around the motor shaft.

2. Place the belt around the agitator pulley on the agitator

assembly.