Care and Cleaning of Your Microwave Oven (continued)
Cleaning Vent Grille (Oven Air Vent)
1.Moisten a soft cloth in hot water containing mild detergent.
2.Wipe the front surface gently.
3.Tilt the Grille cover forward slowly as shown in Fig. A.
(Fig. A)
4.Wipe inside the Grille cover.
To avoid the risk of injury when cleaning, DO NOT directly contact the metal edges of the Grille cover.
Installing the replacement Charcoal Filter (NN-CF203)
This product is shipped for use in the top exhaust ventilation mode.
If you wish to install this product without using an exhaust duct, the exhaust must be recirculated through the front grille and the charcoal filter. This product is shipped with a standard charcoal filter already installed.
The Charcoal Filter cannot be cleaned and should be replaced periodically every 6 to 12 months, or more often if necessary. When necessary to replace the charcoal filter, it can be pur- chased from your local Panasonic dealer.
The part number of the replacement charcoal filter is NN- CF203, refer to the following instructions for replacement.
1.Remove the Vent Grille
Pull the front louver down to open as shown in Fig. B. Remove two screws from the front and one from the top, then pull the Vent Grille forward.
Screws
(Fig. B)
2.Remove the Standard Charcoal Filter
Insert your finger under the bottom of the filter, and pull the Charcoal Filter forward as shown in Fig.C.
(Fig. C)
3.Install replacement Charcoal Filter
Install the Charcoal Filter aligning the two holes, then secure with two screws as shown in Fig. D.
Screw
Screw
(Fig. D)
Installing Vent Grille
1.Slide the top flange of Grille along the top plate, then tilt the Grille down to fit as shown in Fig. E.
Top flange of Grille
Top Plate
(Fig. E)
2.Tilt the front louver downwards, then secure with three screws, one on each side and one on top as shown in Fig. F.
Screws
(Fig. F)
25
