Before Requesting Service
These things are normal:
The oven causes | Some radio and TV interference might occur when you cook | |
interference with | with the microwave oven. This interference is similar to the | |
my TV. | interference caused by small appliances such as mixers, | |
| vacuums, blow dryers, etc. It does not indicate a problem with | |
| your oven. | |
|
|
|
Steam accumulates on the oven door and warm air comes from the oven vents.
During cooking, steam and warm air are given off from the food. Most of the steam and warm air are removed from the oven by the air which circulates in the oven cavity. However, some steam will condense on cooler surfaces such as the oven door. This is normal. After use, the oven should be wiped dry (see page 24).
PROBLEM
Oven will not turn on.
Oven will not start cooking.
POSSIBLE CAUSE | REMEDY |
The oven is not plugged in | Remove plug from outlet, wait |
securely. | 10 seconds and |
Main circuit breaker or main | Reset main circuit breaker or |
fuse is tripped or blown. | replace main fuse. |
There is a problem with the | Plug another appliance into the |
outlet. | outlet to check if it is working. |
The door is not closed | Close the oven door securely. |
completely. |
|
Start Pad was not | Press Start Pad. |
pressed after programming. |
|
Another program is already | Press Stop/Reset Pad to |
entered into the oven. | cancel the previous program and |
| enter new program. |
The program is not correct. | Program again according to the |
| Operating Instructions. |
Stop/Reset Pad has | Program oven again. |
been pressed accidentally. |
|
The Glass Tray wobbles.
When the oven is operating, there is noise coming from the glass tray.
The word "Child" appears in the Display Window.
The oven stops cook- ing and "H97" or "H98" appears in the display window.
The Glass Tray is not positioned properly on the Roller Ring or there is food under the Roller Ring.
The Roller Ring and oven bottom are dirty.
The CHILD SAFETY LOCK was activated by pressing Start Pad 3 times.
The oven unit power supply source failed.
Take out Glass Tray and Roller Ring. Wipe with a damp cloth and reset Roller Ring and Glass Tray properly.
Clean these parts according to
Care and Cleaning of your Microwave Oven (see page 24).
Deactivate CHILD SAFETY LOCK by pressing Stop/Reset Pad 3 times.
Please contact an authorised Service Center (see page 26).
25
