![](/images/new-backgrounds/1307374/30737449x1.webp)
First Time Setup
For your convenience, First Time Setup menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures displayed
Language
The language of the
Procedure
1.Press ▲▼ to select “Language”.
2.Press OK to display the Language menu.
First time setup
Language
Auto program
Picture
3.Press ◄► to select “English,” “Español” or “Français”.
4.Press RETURN to go to previous screen.
Language
Language English
Auto program
You can scan All (Analog and Digital) channels. If needed, follow the menus and procedures displayed
Procedure
1.Press ▲▼ to select “Auto program”.
2.Press OK to display the Program channel menu.
First time setup
Language
Auto program
Picture
3.Press ▲▼ to select “ANT in”.
4.Press ◄► to select “Cable” or “Antenna”.
Program channel
ANT in | Cable |
Auto
5.Press ▲▼ to select “Auto”.
6.Press OK to display the Auto program menu.
Program channel
ANT in | Cable |
Auto |
|
7.Press ▲▼ to select “All channels”, “Analog only”, or “Digital only”.
8.Press OK to start scan.
• Channels available for reception will be set automatically.
Auto program
All channels
Analog only
Digital only
Auto program
Scanning digital channel
Progress
Quit40%
9.After Auto program is complete, the unit will return to Manual program mode. To place the channels that were located by auto scan in memory, move the cursor to “Apply” and press OK. (p.
If OK is not pressed after selecting APPLY, the channels will not be memorized.
10.Press ▲▼ to select “Picture”.
11.Press OK to display the Picture menu. (p. 35)
First time setup
Language
Auto program
Picture
Notes
•After “Auto program” is completed the unit tunes to the first channel found during “Auto program”.
•If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then try “Auto program” again. (p.
•“Auto program” must be done when you select the input signal for the first time or whenever you change the antenna configuration.
•Depending on conditions, “Auto program” may take a while.
Basic Operation
25