Panasonic PT-DZ6700E manual Projecting a image,  Switching on the projector, Basic Operation

Projecting

Projecting a image

 Switching on the projector  Making adjustment and selection

When using an optional lens, install a projection lens before switch on the projector.

1.Connect the supplied mains lead (220 - 240 V AC, 50 Hz/60 Hz) to the AC IN terminal.

2.Remove the projection lens cover from the lens.

3.Switch the POWER switch on that is on the side of the projector.

The power indicator lamp on the projector will flash in red. After a short period, the indicator will illuminate and the projector will enter standby mode.

POWER switch
	AC IN terminal

4.Press the POWER ON button

The power indicator lamp illuminates in green and soon the image is projected on the screen.

POWER ON button

It is recommended that the projector be allowed to warm up for at least 30 minutes before any adjustments are made to the focus.

1.Roughly adjust the focus of the lens.

2.Select and set the projection scheme of INSTALLATION and COOLING CONDITION settings in PROJECTOR SETUP menu.

3.Select the input signal by pressing the INPUT SELECT buttons.

4.Adjust the vertical tilt of the projector with the front leg adjusters.

5.Adjust the shift position of the projection.

If the input signal is RGB signal, additionally press the AUTO SETUP button to adjust the position of the image.

6.Zoom the lens so the image fills the screen.

7.Readjust the focus.

8.Readjust the zoom so that the image size fits in the screen.

Adjusting focus, zoom and shift

Control buttons of the	Pressing the LENS button changes the
	setup screen in order of FOCUS, ZOOM
projector
	and SHIFT. Press F G I H to adjust.
	Press FOCUS, ZOOM or SHIFT button
Remote control buttons to display the setup screen. Press F G
	I H to adjust.
	INPUT SELECT buttons

Basic Operation

.

NOTE:

•If the projector is powered up at about 0 °C (32 °F), a warm- up period of approximately 5 minutes may be necessary to start projection. The temperature monitor (TEMP) lamp lights up during the warm-up period. When the warm-up is completed, the temperature monitor (TEMP) lamp turns off and the image is projected on the screen.

•If the temperature of the operating environment is low and warm-up takes more than 5 minutes, the projector will judge that a problem has occurred and the power will be turned off automatically. If this happens, increase the temperature around the projector so that it is 0 °C (32 °F) or higher, and then turn on the POWER switch and press the POWER ON button again.

LENS button

CAUTION:

•Be careful not to catch your fingers between the lens and shroud when shifting the lens.

NOTE:

•The setup screen will be displayed with the optional fixed lens though, it will not be functioning.

•Pressing F G I or H for 3 seconds or more, performance the adjustment faster.

ENGLISH - 19