Started Getting

Connections

Before connecting to the projector

zzRead carefully the instruction manual of the device you intend to connect. zzTurn off the power switch of the device before connecting the cable.

zzIf a connection cable is not supplied with the device and the optional cable is not available, prepare a connection cable to suit the device.

zzVideo signals containing too much jitter may cause the images on the screen to randomly wobble. In this case, a time base corrector (TBC) must be connected.

zzThe projector accepts the following signals: video signals, S-video signals, analog RGB signals (synchronous signals are TTL level), and digital signals.

zzSome computer models are not compatible with the projector.

zzWhen connecting a device to the projector using a long cable, it may not be possible to achieve a normal picture without a compensator.

zzFor details of the video signals supported by the projector, refer to “List of compatible signals” ( page 111).

Connecting example: Computers

&RPSXWHU

 

6HULDOFDEOH

 

 

VWUDLJKW

 

7RVHULDORXWSXW

7R6(5,$/,1!WHUPLQDO

 

 

%1&FDEOH

7R*%5++99,1!WHUPLQDO

7RPRQLWRURXWSXW

'6XEFDEOH

7RPRQLWRURXWSXW 7R$1$/2*,1!WHUPLQDO

'9,+'0,FDEOH

7RPRQLWRURXWSXW 7R+'0,,1!WHUPLQDO

'9,'FDEOH

7RPRQLWRURXWSXW 7R',*,7$/,1!WHUPLQDO

Note

zzUse an HDMI High Speed cable that adheres to the HDMI standard. Use of a cable that does not adhere to the standard may result in abnormal operation such as cut-out of the image, failure to project, etc.

zzThe <HDMI IN> terminal can be connected with an external device with a DVI terminal using an HDMI/DVI conversion cable. With some devices, however, normal operation may not be possible and images may not appear. ( page 76)

zzWhen the <DIGITAL IN> terminal is used, normal operation may not be possible with some devices and images may not appear.

zzThe <DIGITAL IN> terminal (in the digital signal input mode) is compatible only with single link signals.

zzFor details of RGB signals from computers that the projector supports, refer to “List of compatible signals” ( page 111).

zzIf you operate the projector using the computer with the resume feature (last memory), it may be required to reset the resume feature.

zzThe <DIGITAL IN> terminal (in the digital signal input mode) may require the EDID setting depending on the connected device.

zzTo connect the projector with a computer over a wired LAN, refer to the “Operating Instructions – Network Operations” on the supplied CD-ROM.

36 - ENGLISH