ENGLISH - 32
Settings
PICTURE menu
Depending on the projection environment, you can use
these preset parameter settings to optimise image
projection. Press I H to cycle through the options.
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
You can adjust the brightness of the projected image.
You can adjust the colour saturation of the projected
image. (Available with signals of VIDEO/S-VIDEO/
YPBPR only)
You can adjust the skin tone in the projected image.
(Available with signals of VIDEO/S-VIDEO/YPBPR only)
You can adjust the sharpness of the projected image and
the adjustable range depends on the input signal.
You can adjust the white balance of the projected image.
Press IH to cycle through the options.
STANDARD Balanced white
HIGH More bluish
LOW More reddish
You can keep the projected image bright and vivid even
in well-lit rooms where the ambient light sources cannot
be controlled, such as when a door opens or when
window coverings fail to block out sunlight.
AUTO: Automatic adjustment
ON: Active
OFF: Deactive

PICTURE MODE

NATURAL Reproduces the original colour of
the image
STANDARD Setting for a general image
DYNAMIC Bright and sharp setting
BLACKBOARD
Setting for when projecting on a
blackboard
See “BLACKBOARD” on
page 38.
NOTE:
It may take for a while until the selected mode is
stabilised.

CONTRAST

BRIGHTNESS

MENU
RETURN
Remote control Control panel
See “Navigating through the MENU” on page 29.
See “Main menu and Sub-menu” on page 30.

HigherLower

BrighterDarker

COLOR

TINT

SHARPNESS

COLOR TEMPERATURE

DAYLIGHT VIEW

NOTE:
Do not cover the Ambient Luminance Sensor (ALS) of
the projector. See “Ambient Luminance Sensor (ALS)”
on page 14.
AUTO is not available when INSTALLATION setting in
OPTION menu is set to REAR/DESK or
REAR/CEILING.

DarkerLighter

More

greenish

More

reddish

More

sharp

Less

sharp