Panasonic PV-D4745S manual Review, Replace or Clear Program Contents

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

Review, Replace or Clear Program Contents:

(Recording is not in progress)

	Press PROG
1 to display Program List.
2		Press
		to select number.
3	To Replace program...

Repeat Step 2 (p. 24) to set new programs.

or

To Clear program...

Press ADD/DLT.

To cancel a Timer

Recording in progress...

Hold down STOP in VCR mode for a few seconds to cancel the Timer Recording.

( The TIMER Light-up Indicator goes out on DECK.)

•Any future daily or weekly recording will be performed as programmed.

VCR Operation

4 Press PROG

to end the programming.

Notes

•If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to the Cable Box input channel and Cable Box must be manually set to the desired channel. Cable Box power must be left on.

•2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC” appears and TIMER Light-up Indicator flashes.

Be sure a cassette with record tab is loaded and DECK is in Stop mode.

•If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION” appears on-screen, please re-enter the timer programs.

•If the start time for Timer Recording comes up during recording and playing back, Timer Recording will not be performed.

Important notes when using DSS Receiver

•When recording programs via DSS Receiver, DSS Receiver must be left on.

•When recording programs via an antenna or cable, DSS Receiver must be turned off.

25