34
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Digital Still Camera
Memory Card* (optional)
Insertion/ Removal
Before you begin...
• Connect Camcorder to power source.
• Set POWER to OFF.
*Memory Card: MultiMediaCard or SD Memory Card.
Captured images will be stored on the Memory Card.
Be sure to insert the Memory Card before using the Built-in Digital Still Camera.
Listed below are the Memory Cards which can be used with this Camcorder.
Note:
• If Memory Card is not inserted, “NO CARD”
appears on-screen.
• Do not insert card in wrong direction.
(This would become the basis for trouble.)
• If “CARD ERROR” appears on-screen, see
page 56.
■Concerning the Memory Card
• Except for some special features, this card is compatible with other Panasonic brand
products, like Digital Camera (DMC-LC5, DMC-F7).
• Panasonic only guarantees compatibility with Panasonic brand cards and those bearing
the SanDisk logo.
• This Camcorder can capture a maximum of 699 still images because of camera
memory capacity.
In order to capture 699 images, a larger Memory Card (optional) with approx. 62 MB of
memory is needed for FINE mode and approx. 21 MB is needed for Normal mode.
2
1
Cautions for the Memory Card :
• While Memory Card data is being read, do not remove it, turn off the power, or subject
unit to vibrations and shocks.
• Do not leave the Memory Card in a place with high temperature, exposed to direct
sunlight, or where electromagnetic waves and static electricity can be generated.
• Electromagnetic waves, static electricity, malfunction of the Camcorder or of the
Memory Card itself could erase the data recorded on it. To prevent the loss of picture
data, we recommend that you make a backup copy on the computer.
• Do not bend or drop the Memory Card as this could damage it or the captured contents.
• Do not touch the connector on the rear edge of the Memory Card with your fingers, and
take care that no dirt, dust or water enters it.
• Do not affix other labels to the Memory Card face or back as Card insertion/removal
may become impossible.
A write protection switch is located on the SD Memory Card. Sliding the
switch to the “LOCK” position prevents writing on or formatting the card.
SD Memory Card write protection switch
Write protection switch
Memory Card
MultiMediaCard (SanDisk brand)
SD Memory Card (optional) (See page 52.)
Capacity
8 MB, 16 MB
8 MB, 16 MB, 32 MB, 64 MB
1Slide TAPE EJECT to open door.
2Insert Memory Card (optional), cropped
corner down, into Card Slot and press in on
bottom of Card until fully inserted. (See
diagram.)
3Push in on bottom of Card to eject.