Panasonic RP-BTD10 Useful functions, Resetting the unit, Auto power off, LED indicator light

Microphone

Left

• Also refer to the operating manual for the Bluetooth® enabled phone.

(Checking and operation steps on the unit are explained below)

Press Call on the unit and answer the call

• During an incoming call, ringtone will sound from the speaker and the LED will blink.

• (HFP only) To reject the incoming call, press and hold Call until the ringtone stops.

Make an outgoing call on the Bluetooth® enabled phone

When making an outgoing call

When answering an incoming call

1 Connect the Bluetooth® enabled phone and unit (→ P. 3)

2

Making a phone call

With Bluetooth® enabled phones (cell phones or smartphones) that support the “HSP” or “HFP” Bluetooth® profile, you can use the unit for phone calls.

• HSP (Headset Profile):

This profile can be used to receive monaural sounds and establish two-way communication using the microphone on the unit.

• HFP (Hands-Free Profile):

In addition to the HSP functions, this profile has the incoming and outgoing calls function.

• During an outgoing call, ringtone will sound from the speaker and the LED will blink.

• To cancel the outgoing call, press Call .

A beep will sound.

Call	• (HFP only) When the phone is
	idle, press and hold Call	for

approximately 2 seconds. An outgoing call will be made to the last dialed number. One short click will sound from the speaker and the LED will blink.

3 Start talking

•The LED will repeatedly blink 2 times during a call.

•The volume can be adjusted during a phone call. For setting instructions, see page 4.

4 Press Call to end the phone call

• A beep will sound.

■Note

• There may be instances when hands free setting needs to be done on the
Bluetooth® enabled phone.
• Depending on the Bluetooth® enabled phone, you may hear incoming and
outgoing call ringtones of the phone from the unit.		ENGLISH
• (HFP only) Press and hold the Call	on the unit for approximately 2 seconds.
The calling device will be switched between the Bluetooth® enabled phone and

the unit.

Useful functions

Resetting the unit

This unit can be reset when all operations are rejected. Connect the unit to a computer using the USB charging cord. Then press the RESET hole with a thin, pointed object. Check that the LED (red) goes out. Keep pressing the RESET hole (→ P. 2) for approximately 5 seconds to reset the unit. All the previous operations will be canceled. (The pairing device information will not be deleted.)

Auto power off

If the unit is silent for approximately 5 minutes and operations for Bluetooth® devices are idle during that period, a beep will sound and the power will be automatically turned off.

LED indicator light

When the battery level is low during use of the unit, the blue blinking LED on the left speaker will change to red. A beep will sound every 1 minute. When the battery runs out, the power will turn off.

VQT5J78

5

5