13
RQT9633
ENGLISH
Stations cannot be selected.
Change the FM frequency step.
1Press [RADIO] to select “FM”.
2Press and hold [RADIO] on the main unit.
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
Cannot charge or operate.
≥Check that the iPod/iPhone is connected firmly. (>8)
≥The battery of the iPod/iPhone is depleted. Charge the
iPod/iPhone, and then operate again.
≥When unexpected operation occurs while using the
iPod/iPhone, connect the iPod/iPhone again or try to
restart the iPod/iPhone.
The remote control doesn't work properly.
≥The remote control and this unit are using a different code.
(>right, “REMOTE ”)
The following messages or service numbers
may appear on the unit's display.
“--:--”
≥You plugged the AC power supply cord in for the first
time or there was a power failure recently. Set the time
(>11).
“ADJUST CLOCK”
≥Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
≥The unit has been left unused for about 30 minutes and
will shut down in a minute. Press any button to cancel it.
“CANNOT SET”
≥Select an audio source other than “VTUNER”.
“CHECKING CONNECTION”
≥The unit is checking the connected iPod/iPhone. If this
display keeps appearing, make sure that iPod/iPhone is
inserted correctly and try again (>8).
“DIMMER”
≥Appears 10 seconds after the volume is turned to “0”.
“ERROR”
≥Incorrect operation is performed. Read the instructions
and try again.
“F61”
≥There is a power supply problem. Consult the dealer.
“ILLEGAL OPEN”
≥Sliding door is not in correct position. Turn the unit off
and on again. If this display appears again, consult the
dealer.
“IPOD OVER CURRENT ERROR”
≥The iPod/iPhone is drawing too much power. Remove
the iPod/iPhone and turn the unit off and on again.
“NODEVICE”
≥The iPod/iPhone device is not inserted correctly. Read
the instructions and try again (>8).
“NO DISC”
≥Insert the disc to be played (>8).
“NO PLAY”
≥A CD that is not in CD-DA format is inserted. It cannot be
played.
“NOT SUPPORTED”
≥You have inserted an iPod/iPhone that cannot be played
(>4). Insert correctly and try again if iPod/iPhone is
compatible.
≥If the iPod/iPhone is compatible, turn it on before
inserting it to this unit.
“READING”
≥The unit is checking the CD information. After this
display has disappeared, start operating.
“START ERROR”
≥Check the iPhone/iPod touch.
Visit the below website for more information:
http://radio.vtuner.com/panasonic/en/
“REMOTE ” (“ ” stands for a number.)
≥The remote control and this unit are using different
codes. Change the code on the remote control.
– When “REMOTE 1” is displayed, press and hold [OK]
and [4] for more than 4 seconds.
– When “REMOTE 2” is displayed, press and hold [OK]
and [3] for more than 4 seconds.
iPod/iPhone operations
Remote control
Messages
SC-HC37~RQT9633.book 13 ページ ２０１２年２月２８日 火曜日 午後３時４３分