14
RQT9708
You can set the timer so this unit turns on at a
certain time every day.
Preparation
Set the clock (>13).

∫Setting the timer

1Press [SETUP] repeatedly to select
“TIMER ADJ” and then press [OK].
2Press [3,4] to set the starting time
(“ON TIME”) and then press [OK].
3Press [3,4] to set the finishing time
(“OFF TIME”) and then press [OK].
≥To display the timer settings, press [SETUP] repeatedly to
select “TIMER ADJ” and then press [OK] once.
(During standby, press [iPod MENU, DISPLAY] twice.)
≥The music source and volume will also be displayed if the
timer is turned on. (>below)

∫Turn the timer on

1Select the music source*1 and set the desired
volume.
2Press [SETUP] repeatedly to select
“TIMER SET” and then press [OK].
3Press [3,4] to select “SET” and then press
[OK].
≥“F” is displayed.
4Press [Í] to turn the unit off.
*1: “CD”, “IPOD” and “FM” can be set as the music source.
≥This unit can be used as normal after the timer is set,
however:
≥Turn the unit to standby mode before the timer start time.
≥Even if the audio source or the volume is changed, the
timer will still use the audio source and volume that was
set when the timer was turned on.
≥To turn the timer off, select “OFF” in step 3.
≥The unit will turn on at the preset time, with the volume
increasing gradually to the preset level.
The sleep timer can turn the unit off after a set time.
1Press [SETUP] repeatedly to select “SLEEP”
and then press [OK].
2Press [3,4] to set the time (in minutes) and
then press [OK].
“SLEEP 30” ,. “SLEEP 60” ,. “SLEEP 90” ,. “SLEEP 120”
^----------------------. OFF (Cancel) (----------------------J
≥The remaining time is indicated on the unit’s display except
when other operations are performed.
≥The play timer and sleep timer can be used together. The
sleep timer always has priority.

Others

As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for 30 minutes.
To cancel this function
1Press [SETUP] repeatedly to select
“AUTO OFF” and then press [OK].
2Press [3,4] to select “OFF” and then press
[OK].
≥To turn automatic standby on, select “ON” in step 2.
≥This setting cannot be selected when “FM” is the source.
The brightness of this unit’s display can be
changed.
1Press [SETUP] repeatedly to select “DIMMER”
and then press [OK].
2Press [3,4] to select “ON” and then press
[OK].
To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1Press [CD] to select “CD”.
2Press and hold [CD] on the main unit and [3]
on the remote control until the main unit’s
display shows “REMOTE 2”.
3Press and hold [OK] and [3] on the remote
control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above by replacing [3] with [4].

Play timer

Sleep timer

Automatic standby

Display brightness

Changing the main unit and

remote control code

SC-HC57~RQT9708.book 14 ページ ２０１２年３月２日　金曜日　午後２時４分