15
RQT9708
ENGLISH
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
Preparation
Connect this unit to the wireless network. (>9)
≥Make sure that the wireless network is connected to the
Internet.
1Press [SETUP] repeatedly to select
“SW UPDATE” and then press [OK].
2Press [3,4] to select “UPDATE? Y” and then
press [OK] to start the update.
{. After the update has finished, “SUCCESS” is displayed.
3Disconnect the AC power supply cord and
reconnect it after 3 minutes.
≥DO NOT DISCONNECT the AC power supply cord while
one of the following messages is displayed.
– “LINKING”, “UPDATING” or “%” (“ ” stands for a
number.)
≥If you do not want to update the unit, select “UPDATE? N”
and then press [OK] in step 2.
≥If there are no updates, “NO NEED” is displayed after step 2.
≥During the update process, no other operations can be
performed.
≥Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
∫Checking the software version
1 Press [SETUP] repeatedly to select “SW VER.” and then
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
To check the Wi-Fi signal strength where the unit is
located.
Preparation
Connect this unit to the wireless network. (>9)
1Press [SETUP] repeatedly to select
“SIG.LEVEL” and then press [OK].
≥The unit’s display shows “LEVEL ”.
(“ ” stands for a number.)
2Press [OK] to exit this display mode.
≥It is recommended to have a signal strength of “3”. Change
the position or angle of your wireless network router or the
unit if the indication is “2” or “1” and see if the connection
improves.
≥If “LEVEL 0” is displayed, this unit cannot establish a link with
the wireless network router. (>17)
≥This function does not work when AirPlay is used.
This unit can turn on automatically from standby
mode when this unit is selected as the AirPlay
speakers.
Preparation
Connect this unit to the wireless network. (>9)
1Press [SETUP] repeatedly to select
“NET STNBY” and then press [OK].
2Press [3,4] to select “ON” and then press
[OK].
≥To cancel this function, select “OFF” in step 2.
≥The factory preset is “OFF”. If this function is set to “ON” the
standby power consumption will increase.
To check the unit’s IP/MAC address.
1Press [CD] to select “CD”.
2Press and hold [– WPS] on the unit and [4] on
the remote control until the unit’s display shows
the IP address.
{. The IP address is partially displayed.
≥To display the MAC address on the unit, repeat the
steps above by replacing [4] with [3].
3Press [3,4] on the remote control to show the
rest of the IP address.
≥Be sure to remove the disc from the disc tray when checking
the address.
≥The “ – ” displayed on the top or bottom left of the display
indicate the first and last units respectively.
Software update
Wi-Fi signal strength
Network standby
IP/MAC Address
SC-HC57~RQT9708.book 15 ページ ２０１２年３月２日 金曜日 午後２時４分