Cassette tape
Top of unit
Cassette lid
The buttons described for “Cassette tape” are mainly for the main unit unless indicated otherwise.
Basic play
1 | Press [0] and insert the cassette. | |
|
| Insert inside |
|
| the guides |
| Forward side |
|
2 | Close the lid by hand. | |
3 | Press [TAPE 3] to start play. | |
| To play the other side of the cassette, turn the cassette over. | |
To |
| Action |
stop tape playback | Press | |
start | Press [TAPE 3] when the unit is OFF with | |
|
| the cassette loaded. |
Press [4/REW/4] or [3/FF/¢] in the | ||
rewind | stop mode. |
Note
•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.
•Endless tapes can get caught up in the deckʼs moving parts if used incorrectly.
Recording
Use normal position tapes.
High position and metal position tapes can be used, but this unit will not be able to record or erase them correctly.
Preparation
Wind the leader tape so that recording can begin immediately.
Recording the radio
1 | Insert the cassette to be recorded. |
2 | Tune to the required station (refer to page 10). |
3 | Press [¶ REC/8] to start recording. |
Recording discs | |
1 | Insert the cassette to be recorded. |
2 | Press [CD 6] and then |
3 | Press [OPEN/CLOSE 0] to insert the disc. Press |
| again to close. |
4 | Press [PLAY MODE] on the remote control to select |
| your desired mode (refer to page 7). |
5 | Press [¶ REC/8] to start recording. |
Recording programmed tracks | |
1 | Insert the cassette to be recorded. |
2 | Program the tracks you want (refer to page 8). |
3 | Press [¶ REC/8] to start recording. |
Other basic operations
To | Action | |
erase a recorded | 1) | Insert the cassette to be recorded. |
sound | 2) | Press [TAPE 3] and then |
| 3) | Press [¶ REC¥8]. |
|
| |
stop recording | Press | |
|
|
|
stop recording | 1) | Press [¶ REC¥8]. |
temporarily | 2) | Press again to resume recording. |
|
| |
record on the other | Turn the cassette over and press | |
side of the tape | [¶ REC¥8]. |
You can perform the same operation of [¶ REC¥8] on the main unit by pressing [REC ¶¥8] and [TAPE] simultaneously on the remote control.
ENGLISH
TPS (Tape Program Sensor)
This function enables you to search the beginning of a track, up to a maximum of 9.
Press [4/REW/4] or [3/FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
•with short silent parts
•when noise occurs between tunes
•if silent parts found within tunes
Erasure prevention
The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown.
|
| To |
| Side A | Normal tape |
|
| |
Tab for | Tab for | Adhesive tape |
| ||
side B | side A |
|
RQTV0097
9