Panasonic RX-D17, RX-D19 operating instructions CDs, Normal play Program play, CD play modes

CDs

Normal play

23 1 5

4

Program play

You can program up to 24 tracks.

2 1 3

1	Switch [	] to “CD”.
	(Unit comes on.)
2	Push [c CD OPEN/CLOSE] to
	open the CD lid and insert the

CD.

Label must face upward.

Ensure CD is stopped before programming.

1 Press [–/g] or [f/+] to select the desired track.

2 Press [MEMORY].

The track is programmed.

Track number Play time

Program order

3 Push [c CD OPEN/CLOSE] to close the CD lid.

Total playing time

Total number of tracks

Repeat steps 1 and 2 until you have programmed all the tracks you want.

Specified track number

Total play time of programmed tracks

4 Press [-/ J] to start play.

Play starts from the first track and continues to the last track.

Elapsed play time

3 Press [-/ J].

Play starts in the programmed order.

Track number in play

5 Adjust the volume.

To stop play

Press [L].

To pause	Press [-/J] during playback.
	To resume, press [-/J].
To search forward/	Hold down [–/g] (backward) or [f/+]
backward	(forward) during playback or when paused.
To skip forward/	Press [–/g] (backward) or [f/+]
backward	(forward) during playback or when paused.

“NO DISC” is displayed if there is no disc in the unit.

Note

•If interference occurs to radios or televisions, place the unit as far as possible from this equipment.

•Do not press [c CD OPEN/CLOSE] during play, pause or immediately after you inserted the CD and closed the CD lid. CD may be scratched.

This unit can play CD-DA (digital audio) format audio CD-R that has been finalized (a process that enables CD-R players to play audio CD-R) upon completion of recording.

It may not be able to play some CD-R due to the condition of the recording. It cannot play CD-RW.

To stop play

Press [L].

“P” is displayed indicating that the program is still active.

Press [L] again and “CLr” is displayed; the program is cleared, and the normal play mode is restored.

To check program contents

Press [–/g] or [f/+] when “P” is displayed.

Display

“— —:— —”: Program equals, or exceeds, 100 minutes but program- ming and play are still possible.

“FULL”: 24tracks have already been programmed. The program is full.

CD play modes

You can repeat one track ( ), all tracks () or play the tracks in

random order ().

Press [CD PLAY MODE] before or during playback to select the desired mode.

off (no indication)

These modes remain active until cancelled.

You can use repeat mode with program play.

Note

Random and program play cannot be done at the same time.

4

RQT6341

P3-4 4 11/21/01, 7:05 PM