Panasonic RX-D19, RX-D17 operating instructions Radio, Normal tuning Preset tuning

The Radio

Normal tuning						Preset tuning
3	2	1	5	4		Preset the stations (twelve FM and twelve AM) to make tuning simpler.
					1 2 4		3

1 Switch [] to “TUNER”. (Unit comes on.)

2 3 1

How to preset

Preparation: Tune to the desired station. (Do steps 1–4on the left.)

2	Press [BAND] to select “FM” or “AM”.
3	(Omit this step if using the remote control)
	If “	” is on the display, press
	[TUNE MODE] to clear it off.
4	Press [–/g] or [f/+] to
	tune to the desired station.
	The frequency changes one step
	each time a button is pressed.		“ ” lights when an FM stereo
	Automatic tuning		broadcast is being received.

Keep [–/g] or [f/+] depressed and release when the frequency display starts to change. A station with good reception is automati- cally selected and the process stops.

To stop automatic tuning, press [–/g] or [f/+] again.

Note

Automatic tuning may stop on a frequency where there is no station if there is interference. Press [–/g] and [f/+] to tune if this occurs.

5 Adjust the volume.

To use auto scan

You can search for a station by listening to all tuned-in stations for 8 seconds each.

Preparation: Switch [] to “TUNER”.

1.Press [BAND] to select “FM” or “AM”.

2.Press [AUTO SCAN]. Auto scan starts.

Indicates auto scan

3. Press [AUTO SCAN] when you find the desired station.

Auto scan ends when it reaches the original frequency again. To stop during the process, press [AUTO SCAN].

To improve reception

1 Press [MEMORY].

2 While “” and the frequency are flashing

Press [MEMORY].

Preset channel

3 While “” and the preset channel are flashing

Press [–/g] or [f/+] to select the desired channel.

(Remote control: [4] or [3])

4 Press [MEMORY].

(This completes presetting.)

Repeat the above to preset other stations.

Note

1If “ ” goes off during presetting, return to step 1.

To listen to preset channels

2Press [BAND] to select “FM” or “AM”.

(Omit this step if using the remote control)

Press [TUNE MODE] to display

3“”.

Press [–/g] or [f/+] to select the desired channel (1–12).

(Remote control: [4] or [3])

Preset channel

FM: Extend the whip antenna and adjust its direction.

AM: Adjust facing of the unit.

If noise is excessive in the FM stereo mode

Press [FM MODE]. (“ ” lights up.)

Sound will be produced in monaural, but this also reduces noise.

Press the button again to cancel. (“ ” goes out.)

To use preset scan

You can search for a station by listening to all preset channels for 8 seconds each.

1. Do steps 1to 2above.

For remote control, replace [– /g] or [f/+] described below with [4] or [3].

2. Press and hold [–/g] or [f/+] until “PS” appears on the display.

Indicates preset scan

3. Press [–/g] or [f/+] when you find the desired channel.

Preset scan ends after searching through each preset channel once. To stop during the process, press [–/g] or [f/+].

3

RQT6341

P3-4 3 11/21/01, 7:05 PM