Panasonic RX-EX1 The Radio manual tuning, Press TUNER BAND to select FM or AM, Auto-tuning

	FADER	SLEEP	EQ ON
1	REC		ALL 1-REC ST
PGM	RANDOM		MONO
	FADER	SLEEP	EQ ON
1	REC		ALL 1-REC ST
PGM	RANDOM		MONO
	FADER	SLEEP	EQ ON
1	REC		ALL 1-REC ST
PGM	RANDOM		MONO
	FADER	SLEEP	EQ ON
1	REC		ALL 1-REC ST
PGM	RANDOM		MONO

Auto scan

FADER SLEEP EQ ON

1 REC ALL 1-REC

PGM RANDOM MONO

FADER SLEEP EQ ON

			1	REC		ALL 1-REC
			PGM	RANDOM		MONO
	FM		AM
4	5	6	10	FADER	SLEEP	EQ ON
						ALL 1-REC ST
			1	REC
			PGM	RANDOM		MONO
7	8	9	0
AUTO SCAN	C-RESET	FM MODE BP	CD PLAY
			MODE
CLOCK	TAPE	TUNER	CD
TIMER
P

The Radio: manual tuning

Press [POWER, ] to turn the unit on.

Press [TUNER BAND] to select FM or AM.

Each time the button is pressed: AM FM

Press [TUNE MODE] to select the manual tun- ing mode.

Make sure that “” is not displayed.

Press [REW/–/ ] or [ /+/FF] to select a station.

“” is displayed during FM stereo broadcasts.

Turn [– "VOLUME#+] to adjust the volume.

				Listening
Auto-tuning
Press and hold [REW/–/		] or [	/+/FF] until the fre-
quency starts changing rapidly.
Stops when it finds a station. (Interference may also cause
it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [REW/–/	] or [	/+/FF].

Using auto scan

Remote control only

You can search for a station by listening to all tuned-in stations for 8 seconds each.

■Press [TUNER] to select “FM” or “AM”.

■Press [AUTO SCAN].

Auto scan starts.

■Press [AUTO SCAN] when you find the de- sired station.

Auto scan ends when it reaches the original frequency again. To stop during the process, press [AUTO SCAN].

To improve reception

FM: Change the length and position of the antenna.

AM: Change the facing of the unit.

•AM reception is briefly interrupted if a tape deck is operated.

•To improve reception when using the unit in a building or vehicle use it near a window.

If noise is excessive in FM

Remote control only

Press [FM MODE/BP] to display “ MONO ”.

Monaural sound is selected (“” goes off) and noise re- duces when reception is weak.

Press [FM MODE/BP] again to cancel the mode.

To receive FM broadcasts allocated in 0.1MHz

Main unit only

First press [TUNER BAND] to select “AM”. Now, press and hold [TUNER BAND]. The display changes in a few sec- onds to show the current lowest FM frequency. Continue to hold down the button.

The minimum frequency changes and the step is changed at

the same time. Changing the step erases all preset stations. 13 Repeat the above to change the step back.

RQT5671