21
RQT7994 ConnectionsSettingsBasic Operations Before useOperationsReference

Receiver settings

-

Advanced

Any changes to settings remain as set even if the power is turned off.
áPage 24 “Multi control menus and factory settings”.
Use the MULTI CONTROL menus to change the settings.
Set the size so that the speakers can adequately reproduce the bass range.
The following are set automatically.
When you set “FRONT ” toSMALL ”, “SUB-WFR ” is set to “YES ”.
When you set “SUB-WFR ” to “NO ”, “FRONT ” is set to “LARGE ”.
By setting the distance between the speaker’s position (except the
subwoofer) and the listener’s seating position, the sound delay time is
automatically adjusted so that sound reaches the listener at the same
time.
If the Front speakers are set to SMALL ”, make this setting.
Change the cut-off if the bass from the front speakers is unsatisfactory so
that this bass is output through the subwoofer.
This is displayed when you set “BI-WIRE ” in “Bi-wiring settings”. Select
this when you connect bi-wire compatible front speakers.
You can adjust HF (high frequency) and LF (low frequency) output
balance from the bi-wired speakers. You can also adjust the sound delay
time to offset the difference in HF and LF output directions.
Basic operations with the MULTI CONTROL
Turn to change. Press to enter.
n To return to the previous setting/To cancel
Press.
n To select another settings
Press several times to return to step 2 in the
operations across and select another setting.
n To finish settings
Press several times to select “EXIT ” and
press [ENTER].
1Enter the MULTI CONTROL.
Select “SETUP 2 (“ADVANCE SETUP
scrolls once) and press [ENTER].
Select the settings to change. (ábelow, right)

Speaker settings

2Select “SPEAKERS ” and press [ENTER].
3Select the speaker and press [ENTER].
SUB-WFR, FRONT, CENTER, SURROUND, SUR BACK
4Change the setting and press [ENTER].
SUB-WFR: NO, YES FRONT: SMALL, LARGE
CENTER/SURROUND: NONE, SMALL, LARGE
SUR BACK: NONE, 1 SPKR, 2 SPKRS
NONE: For speakers you haven’t connected (center,
surround or surround back).
SMALL: For speakers that cannot adequately reproduce the
bass range. This setting is sufficient for most
speakers if you are using a subwoofer.
LARGE: For speakers that can reproduce a full sound range,
particularly the bass range below 80 Hz.
1 SPKR: If you connect one surround back speaker.
2 SPKRS: If you connect two surround back speakers.
For the subwoofer (SUB-WFR), select “YES ” if you have
connected one, or “NO ” if you have not.
Repeat steps 3 and 4 for each speaker channel.

5