6
RQT9869
Preparing the media

Disc

1Press [USB/CD] to select “CD”.
2Press [CDx] (main unit: [xOPEN/CLOSE]) to open
the sliding door.
Put in a disc with the label facing towards you.
3Press [CDx] (main unit: [xOPEN/CLOSE]) again
to close the sliding door.
Keep fingers away from the sliding door when it is
closing.

USB

Press [USB/CD] to select “USB”.
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
Bluetooth®
You can connect and play an audio device wirelessly
through Bluetooth®.
Preparation
• Switch on the Bluetooth® feature of the device and put
the device near the system.
• Read the operating instructions of the device for
details.
█Pairing a device
Preparation
If this system is connected to a Bluetooth® device,
disconnect it (Z“Disconnecting a device”).
1Press [ ] to select “BLUETOOTH”.
If “PAIRING” is shown, continue with step 4.
2Press [PLAYMENU] to select “PAIRING”.
Or press and hold [ –PAIRING] on the main unit until
“PAIRING” is shown. Continue with step 4.
3Press [R,T] to select “OK?YES” and then press
[OK].
“PAIRING” is shown.
To cancel, select “OK?NO”.
4Select “SC-HC29” from the Bluetooth® menu of the
device.
If prompted for a passkey, input “0000”.
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a few
seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
█Connecting a device
Preparation
If this system is connected to a Bluetooth® device,
disconnect it (Z“Disconnecting a device”).
1Press [ ] to select “BLUETOOTH”.
“BLUETOOTHREADY” is shown.
2Select “SC-HC29” from the Bluetooth® menu of the
device.
The name of the connected device is shown for a few
seconds.
3Start playback on the device.
Note:
• A device must be paired to connect.
• This system can only connect to one device at a time.
• When “BLUETOOTH” is selected as the source, this
system will automatically try to connect to the last
connected device.
█Disconnecting a device
1Press [ ] to select “BLUETOOTH”.
2Press [PLAYMENU] repeatedly to select
“DISCONNECT?”.
3Press [R,T] to select “OK?YES” and then press
[OK].
“BLUETOOTHREADY” is shown.
To cancel, select “OK?NO”.
Using the main unit
Press and hold [ –PAIRING] until “PAIRING” is shown.
Note:
A device is disconnected when you:
• Select a different source.
• Move the device out of the maximum range.
• Disable the Bluetooth® transmission of the device.
• Switch off the system or the device.
USB device
(not supplied)
SC-HC29 DBEB.GN.GS RQT9869-1B EN.fm Page 6 Monday, March 17, 2014 2:31 PM