Panasonic SC-HT880W operating instructions Front and surround, Speaker assembly

Front and surround speaker assembly

Simple setup

STEP1 Front and surround	The supplied stands are specially designed for
	attachment to Panasonic SB-FS930 front speakers
	or SB-FS880 surround speakers. Use only as
speaker assembly	indicated in this setup.

Preparation

≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it. ≥For assembly, use a Phillips-head screwdriver.

≥Make sure you have all the indicated components before starting assembly, setup, and connection. ≥There is no difference between the right and left speakers and pipes.

[Note]

≥To prevent the speaker cables from being pulled out of the pipes, leave the plastic wrap on the pipes while assembling the speaker stands. ≥The front and surround speaker pairs as well as the pipe pairs are different.

–Check the label on the rear of the speaker before attaching the pipe (➜ page 5). –The pipe with the shorter cable is for the front speaker.

2 Front and 2 Surround	Pipes
speakers	≥2kpipes with short cable: For front speakers	4 Bases	8 Long screws	8 Short screws
	≥2kpipes with long cable: For surround speakers

1 Assemble the speaker stands.

1Thread the speaker cable through the base.

For quicker threading, loosely fold the cable in half (do not crease), pass the folded portion through the hole, and then pull the rest of the cable through the base.

3 Connect the speaker cables.

Rear of the speaker

Twist off the vinyl ends of the

Plastic wrap

Leave the excess speaker cable for connecting later.

2Insert the pipe.

Pipe

Groove

Pipe support

Base

Cable

Base

Match the groove and these holes with the base when you insert the pipe.

Insert the pipe while gently pulling on the speaker cable.

speaker cables.

_: Copper

`: Silver

Push!

Press the speaker cable into the groove.

If there is any excess speaker cable, thread the speaker cable into the opening near the top of the pipe while pulling the speaker cable from the bottom of the base.

4 Secure the speaker cables to the bases.

Press the speaker cable into the base cover groove as far

RQT7991

4

3Secure the pipe to the base.

Ensure the screws are securely fastened.

Phillips-head

screwdriver (not included)

Short screws

Before proceeding to the next step, please remove the plastic wrap from the pipe.

2 Attach the stands to the speakers.

Ensure the stand is fastened on straight by gradually tightening the top and bottom screws alternately until fully tightened.

Long screws

Pipe

Speaker

You can also attach to the lower rear of the speaker.

The height of the speaker can be changed when attaching the stand to the upper rear or lower rear of the speaker.

as possible.

Rear side of base

Cable

Groove

∫Preventing the speakers from falling over

Preparation

Attach screw eyes (not included) to secure the speakers to the wall (➜ diagram below).

≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.

≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support. Improper attachment may result in damage to the wall or speakers.

1Thread the string (not included) through the slot on the rear of the speaker to prevent it from falling over.

2Loop the string through the screw eye and tie tightly. Screw eye (not included)

String (not included) Wall

Approx. 150 mm

Rear of the speaker